Gronomics VG 32-45UA Assembly Instruction Manual

Vertical Garden Bed 32” x 45”

3

1

2

4

5

6

7

8

9

11

12

13

14

10

1

Assembly Instruction

Parts Identifi cation

Stack matching pieces in piles. Using the parts
list, locate and count the individual pieces and
verify that you have received the correct number
of pieces.

If any pieces are missing or replacement parts

are required, contact Gronomics at
1-855-299-6727.

NOTE: Ground preparation is optional, however
we recommend leveling area under frame of
product, or place product directly on a flat level
surace before filling with soil.

Product care and Maintenace Western Red

Cedar will turn a weathered grey if left unfinished. Although no
finish is required for cedar when used outdoors, a natural oil
finish applied regularly will help maintain the beauty and
minimize cracking and drying. It is recommended to use
Gronomics Garden Bed Oil (Item # GBO-1Q), a
non-toxic, food safe finish that is very easy to apply. Apply

Oil when air and wind temperatures are between
50-90degrees. Avoid applying in direct sunlight.

Item #: VG 32-45UA

Torx® T15

13

14

10

11

Torx® T25

12

Parts List

ITEM QTY. PART # DESCRIPTION

1 1 4550SRB Side Panel (Right Hand) 45-1/2” x 8-7/16” x 1-1/4”
2 1 4550SLB Side Panel (Left Hand) 45-1/2” x 8-7/16” x 1-1/4”
3 7 3054BKB Back Boards 30” x 5.41” x 5/8”
4 7 3050AFB Angled Front Shelf Boards 30” x 5” X 5/8”
5 1 2925BMB Bottom Board 29-1/4” x 5.41” x 1” (w/ 4 Pre-Drlled Holes)
6 1 V1204 Top Back Board (w/ 2 Pre-Drilled Holes) 30” x 5-1/4” x 5/8”
7 1 V1205 Angled Front Shelf Board (w/ Logo) 30” x 5” x 5/8”
8 2

9 4

RSS10-234ZY

RSS10-112ZY

Screw, RSS GRK 10 x 2-3/4"

Screw, RSS GRK 10 x 1-1/2"

10 1 YFL Fabric Liner 36” x 10-1/4”
11 1 GBDIK
12 1 N/A
13 1 N/A
14 5 SCEY6Z

Garden Bed Drip Irrigation Kit (Contains Items 12 - 14)
Irrigation Tubing 16’
Hose Connector
Eyelet Screws

Packaged & Inspected by: Date:

Continued

www.gronomics.com East Bethel, MN USA 763-753-7374

Side Panel Assembly

2

1

2

4

9

5

5

5

3

3

3

2

1

Slots

Bottom Board Assembly

Place the two side panels 45-1/2” x 8-7/16” x 1-1/4” (Item
1 & 2) on the ground with the slots facing each side panel
and slots slanting away from you.

Slots

Install the bottom board 29-1/4” x 5.41” x 1” (Item 5) onto
the side rails cleats (as shown). Install four 2” screws (Item

9) through the pre-drilled holes of bottom board and tighten
screws into the cleats located on the side panels.

Slots

Back Board Assembly

Locate and install one back board 30” x 5.41” x 5/8” (Item

3) into the long straight slot on the bottom side of each
side panel (Item 1 & 2). Slide the back board down, until it
is fl ush with the top of the side panels.

Bottom

To p

To p

Back Board Assembly Continued

Slide the back board 30” x 5.41” x 5/8” (Item 3)
from the top of the side panels down until it makes
contact with the bottom board (Item 5).

To p To p

Continued

www.gronomics.com East Bethel, MN USA 763-753-7374

4

6

Angled Front Shelf Board Assembly

7

3

Locate and install one angled front shelf
board 30” x 5” X 5/8” (Item 4) into the
lowest slot of the side panels. Install the
angled front shelf board into the side
panel slots with the beveled edge (front
edge) facing you.

Beveled Edge

Back Board Assembly Continued

Stand the assembly up.

Locate and install the remaining back boards (Item 3).
Slide the back boards down until they make contact
with the previous back board installed.

Continued

www.gronomics.com East Bethel, MN USA 763-753-7374