Grohe 04057XX0, 04059XX0 Installation Instructions Manual
S
04057XX0
E
04059XX0
Installation Instructions / Warranty
2
Wall-mounted Pot Filler S 04057XX0
Wall-mounted Pot Filler E 04059XX0
04057XX0
04059XX0
3
Installation Considerations
For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber.
Please read over these instructions thoroughly before beginning installation. Make sure
that you have all tools and supplies needed to complete the installation.
•
•
Technical Information
Recommended water pressure 14.7 - 72.5 psi
Hole size in mounting surface 1 3/16"
Max. wall thickness 1 1/2"
Flow rate 2.2 gpm
This faucet is intended for cold water only.
This faucet requires a 1/2" NPT male nipple,
extending 1/2" outside the surface of the
finished wall.
Stud supports for the mounting flange must be
installed.
Extreme care should be taken to avoid damage to hidden electrical or plumbing lines
when drilling the screw holes.
Do not use petroleum based plumbers putty. If
desired, seal around the flange with silicone
sealant.
•
•
•
•
Installation
Wrap the threads on the nipple with Teflon tape.
Install the mounting flange. It should be centered
over the nipple.
Caution: while drilling the screw holes, use
extreme caution not to damage hidden electrical
or plumbing lines.
Loading...