Gro VGS Series, VGS Irrigation System, VGS Casters Package Assembly Manual
Innovative Solutions for Gardeners Everywhere!
®
AAsssseemmbbllyy MMaannuuaall
©© 22001144 GGRROO PPrroodduuccttss AAllll RRiigghhttss RReesseerrvveedd
GRO Products • P.O. Box 248 Genoa, IL 60135 • 877.442.9267 • www.groproducts.com
VVeerrttiiccaall GGrroowwiinngg SSyysstteemmss
The feet will come with the bolts tight. On both
feet, loosen both bolts as far as they will go while
remaining attached to the receiving T-nut.
Start with the VGS bottom (the section without the
GRO Products logo) and attach the bracket onto the
leg using the provided bolt & allen wrench as
shown above. Do this on both sides of the bottom
section.
NNOOTTEE:: TThhee bbrraacckkeettss ccaann bbee ssnnuugg.. TThhiiss iiss nnoorr--
mmaall.. YYoouu mmaakkee hhaavvee ttoo ssqquueeeezzee tthheemm oonnttoo tthhee lleeggss..
Place the VGS bottom into the feet with the brack-
ets facing up. Make sure that the flat side of the
slats are facing the front of the feet.
Insert the loose slat into the groove at the top of
the VGS bottom, keeping the flat side of the slat to-
wards the front of the VGS like the pre-installed
slats.
Slide the VGS top into the brackets, making sure
the loose slat goes into the groove on the VGS top
and that the flat portion of the slats are all facing
the front of the VGS.
1.
2.
3.
6.
4.
5.
F
R
O
N
T
Put all the plastic liners into the hanging wooden
boxes. Remember to punch out the draingage
holes in each plastic liner if needed.
Loading...