MODEL T32735
Wear personal protective equipment to
Keep hair, clothing, and
ing parts at all times.
Entanglement can result
in death, amputation, or
ANGLE GAUGE
FOR T32732
INSTRUCTIONS
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
Introduction
The Model T32735 Angle Gauge adjusts between
0°–24° left or right to allow you to consistently
produce exact, repeatable angles on turning tools.
Inventory
Description Qty
A. Angle Gauge .............................................. 1
Hex Wrench 2.5mm .................................... 1
B.
Using Angle Gauge
The gauge slides into the table of the T32732
Bench Grinder Sharpening System to sharpen
skews, scrapers, cutters, and other tools needing
a precise angled edge.
Eye and face injuries and respiratory problems can occur while operating this tool.
To use angle gauge:
DISCONNECT GRINDER FROM POWER!
1.
2. Place angle gauge in T-slot of T32732 table
(see Figure 1).
Adjust gauge to desired bevel angle, then
3.
tighten (2) button head cap screws shown in
Figure 1 to secure.
T-Slot
Gauge
x 2
reduce your risk from these hazards.
jewelry away from mov-
severe crushing injuries!
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
COPYRIGHT © OCTOBER, 2021 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
(FOR MODELS MFD. SINCE 10/21) #CS22116 PRINTED IN TAIWAN
Figure 1. Angle gauge in use.
Adjust table and short arm so tool bevel con-
4.
tacts grinding wheel when it is aligned with
angle gauge.
Note: Clearance between table and grinding
wheel should be
Tilt tool away from grinding wheel, connect
5.
grinder to power, and turn machine ON.
Use firm grip to return tool to surface of grind-
6.
ing wheel to perform grinding operation.
1
⁄16" or less.
V1.10.21
Loading...