Grizzly T31616 User guide

MODEL T31616

VARIABLE-SPEED

AIR MOVER

INSTRUCTIONS

For questions or help with this product contact Tech Support at [phone] or [e-mail]

Introduction

This variable-speed air mover offers two built-in
outlets to connect multiple units, and sits in four
different positions for ease of placement.

Specifications

• Motor ......................... 120V, 1-Ph, 60 Hz, 1A

• Maximum Total Current Rating ............... 15A

• Speed ................................... 900-1500 RPM

• Maximum Airflow ........................... 300 CFM

• To avoid electric shock, do not handle
plug or machine with wet hands and do
not expose to rain or place directly in wet
area.

• Disconnect power before servicing,
cleaning, or when machine is not in use.

• Only plug power cord into a grounded
outlet.

• Keep hair, loose clothing away from fan.

• Do not modify machine in any way.

• Do not use if cord/plug becomes dam­aged—only replace with Ground Fault
Circuit Interrupter plug (GFCI).

• Do not run cord under carpeting or where
it may be tripped over.

• Not meant for outdoor use.

• To avoid fire, do not use in area with
flammable or combustible liquids/fumes.

• Prevent unauthorized use by children or
untrained users.

Operation

1. Place air mover at desired position with air

inlets and outlet unobstructed and on a level
surface (see Figure 1).

Air Inlet

(1 of 2)

Air Outlet

Figure 1. Air circulation.

Make sure variable-speed dial is OFF (see

2.
Figure 2), then plug into a GFCI-protected

outlet.

Variable-Speed

Dial

120 VAC Outlet

(1 of 2)

Figure 2. Power components.

Power

Cord

COPYRIGHT © SEPTEMBER, 2019 BY GRIZZLY INDUSTRIAL, INC.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#CS20628 PRINTED IN CHINA

V1.0 9.19

3. Turn speed dial to desired speed setting to
turn air mover ON.

Note: If air mover stops operating while still

connected to power and with speed dial
turned ON, circuit overload may be tripped.
To reset, make sure air mover is dry, vents
are unobstructed, and that it is not overheat­ing, then press reset button (see Figure 3).

Reset

Button

Figure 3. Reset button location.

Follow Steps 1–3 to connect additional air

4.

mover devices to two built-in outlets (see
Figure 2). Disconnect from power when not
in use.

Note: Do not exceed 12A of current draw

between two built-in outlets, i.e., 6A max. is
limit for each receptacle.

-2-

T31616 Variable-Speed Air Mover (Mfd. 9/19+)