Page 1
MODEL T28367 STAND
MACHINE/STAND
MOUNTING INSTRUCTIONS
(For Models Manufactured Since 03/18)
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
Introduction
The Model T28367 stand is designed specifically
for the T28366 10" Slow Speed Cold Cut Saw.
The stand is 25
1
⁄2 ".
by 12
A
1
⁄2 " tall, with a top that is 153⁄4" wide
Anchoring the stand to the floor prevents the
machine from tipping or shifting and reduces
vibration that may occur during operation, resulting in a machine that runs slightly quieter and
feels more solid.
Local codes may require anchoring stand to the
floor. If not required by any local codes, fastening stand to the floor is an optional step. If you
choose not to fasten the stand to floor, we recommend placing it on machine mounts (shown
on next page in Accessories). These provide an
easy method for leveling and they have vibrationabsorbing pads.
Lag shield anchors with lag screws (see below)
are a popular way to anchor machinery to a concrete floor, because the anchors sit flush with the
floor surface, making it easy to unbolt and move
the machine later. However, any time local codes
apply, you MUST follow the anchoring methodology specified by the code.
Figure 1. Model T28367 Stand.
Inventory
Description Qty
A. Stand .......................................................... 1
B. Hardware Bag (Not Shown)
—Cap Screws M10-1.5 x 20 ....................... 2
—Hex Nuts M10-1.5 ................................... 2
—Flat Washers 10mm ................................ 2
Anchoring Stand to Floor
Number of Mounting Holes ............................... 4
Diameter of Mounting Hardware .....................
(Hardware not included)
COPYRIGHT © APRIL, 2018 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#ES19556 PRINTED IN CHINA
1
⁄2 "
Lag Screw
Flat Washer
Stand Base
Concrete
Figure 2. Popular method for anchoring
machinery to a concrete floor.
Lag Shield Anchor
Drilled Hole
V1.0 4.18
Page 2
Mounting Machine to Stand
To avoid serious crushing injury and
prevent equipment damage, securely mount
machine to stand before operating machine.
Lift and place the machine onto the Model T28367
stand following the instructions included in the
Model T28366 manual.
The stand comes with two mounting holes. Refer
to Figure 3 for mounting hole positions.
Viewed From Above
15¾"
Accessories
G7159—Machine Mount 3" 1600 lb. Capacity
For the ultimate in heavy machine stabilization,
these mounts feature easy setting, fast leveling,
and vibration and noise reduction. Large rubber foot pads distribute weight evenly and long
mounting studs provide a wide range of leveling
adjustment.
14¼"
12½"
6¼"
Front of Stand
Figure 3. Layout of machine mounting holes.
Items Needed: Qty
Hex Wrench 8mm .............................................. 1
Open-End Wrench 10mm .................................. 1
Use (2) M10-1.5 x 20 cap screws, (2) 10mm flat
washers, and (2) M10-1.5 hex nuts to secure
machine to stand, as shown in Figure 4.
M10-1.5 Cap Screw
Figure 5. G7159 machine mount.
10mm Flat Washer
Machine Stand
M10-1.5 Hex Nut
Figure 4. Mounting hardware configuration.
-2-
T28367 Stand (Mfd. Since 03/18)
Loading...