Page 1
MODEL T28171
ZERO-CLEARANCE
TABLE INSERT FOR
G0771 & G0771Z
For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
Front
• DISCONNECT SAW FROM POWER
BEFORE REMOVING OR FITTING
TABLE INSERT!
• Wear eye protection when cutting.
• Do not tilt blade while it is in the insert!
For beveled cuts, a separate insert must
be used only at that angle.
• Only use carbide-tipped blades with this
insert. Wider teeth provide clearance for
the blade body, which reduces heat.
• Use a separate insert for each blade
angle and cutting height. This ensures a
true “zero-clearance” effect.
• When cutting the insert, it MUST be
securely clamped down with a board and
clamps before raising the blade.
• Use extreme caution when cutting blade
slot (kerf). Raise blade very slowly.
Adjust Flat
Head Screws
Cutting Blade Slot (Kerf)
1. Verify insert fits properly and blade is NOT
touching insert. Check this by rotating blade
from below with a push stick or by moving
drive belt.
Firmly clamp a scrap board (at least 3⁄4" thick)
2.
over top of table insert so blade is not visible
as it emerges through insert. This setup helps
prevent chipout and reduces chance of blade
raising insert during cut.
Clamps
Back
Installing & Fitting Insert
1. Lower blade completely and remove blade
guard.
Remove table insert and riving knife.
2.
3. Install new table insert with riving knife slot
to the back (see Figure) so tab on bottom
engages under surface of table. Initially,
insert may be too long and hit on the two front
"fitting bumps."
Using a medium grit sanding block, lightly
4.
sand bumps. While sanding, slightly bevel
bottom edges of bumps to ease entry. Sand,
test-fit, and repeat to gradually “sneak-up” on
a snug, yet easily removable fit.
Adjust five flat head screws to make insert
5.
flush with table.
Board
3. Re-connect saw to power. KEEP HANDS
OFF TABLE TOP AND SCRAP BOARD,
WEAR EYE PROTECTION, AND DON'T
STAND DIRECTLY BEHIND BLADE PATH.
Turn saw ON, then slowly and cautiously
raise blade to correct height for operation.
Lower blade completely and turn saw OFF,
4.
then remove scrap board and insert.
Re-install riving knife, table insert, then blade
5.
guard. Ensure they are in proper operating
condition. Insert is now ready to use.
Note: An undesirable scraping noise may be
generated by blade run-out or distortion. To
remedy this, remove insert and slightly widen
slot, using a file or sanding paddle.
COPYRIGHT © DECEMBER, 2018 BY GRIZZLY INDUSTRIAL, INC. REVISED DECEMBER, 2019 (BL)
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
(FOR MODELS MFD. SINCE 12/19) #RS20060 PRINTED IN CHINA
Loading...