Grizzly T26902 User Manual

MODEL T26902

401⁄2" 14-DRAWER TOOL CABINET

INSTRUCTIONS

For questions or help with this product contact Tech Support at [phone] or [e-mail]

Introduction

The Model T26902 14-Drawer Tool Cabinet
requires some assembly. Follow instructions
below for assembly, operation, and maintenance.

Figure 1. Model T26902.

Inventory Qty

• Tool Cabinet with Drawers ........................... 1

• Handle ......................................................... 1

• Hex Bolts M8-1.25 x 25 ............................. 20

• Flat Washers 8mm .................................... 16

• Lock Washers 8mm ................................... 16

• Fixed Casters .............................................. 2

• Swivel Casters with Brakes ......................... 2

• Keys ............................................................. 2

Assembly

1. Attach handle on preferred side of tool cabi-

net using four M8-1.25 x 25 hex bolts (see
Figure 2). Do not over-tighten!

x 4

• To reduce risk of crushing injuries from
tool cabinet tipping over on you:
— Do not stand on cabinet or in drawers.
— Push cabinet only. Do not pull it.
— Only open one drawer at a time.
— Only move or transport cabinet with all

drawers closed and locked.

• Do not exceed weight capacities:
— Max individual drawer weight limit

is 50 lbs.

— Max tool cabinet weight limit (including

contents) is 1000 lbs.

• To prevent accidental rolling, always lock
brakes after moving cabinet.

• Do not allow children to have unsupervised
access to cabinet.

COPYRIGHT © AUGUST, 2014 BY GRIZZLY INDUSTRIAL, INC.

NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

FOR MODELS MANUFACTURED SINCE 08/2014 #WK16749 PRINTED IN CHINA

Handle

Figure 2. Handle installed.

V1.0 8 .14

2. Remove bottom drawer (refer to Operation
for instructions).

3. Place unit on its top or side.

Removing & Installing Drawers

The drawers can be removed and re-installed if
an object inside causes them not to fully close.

Tip: Use packaging material to protect paint

finish.

4. Attach each caster using four M8-1.25 x 25
hex bolts, 8mm lock washers, and 8mm flat
washers (see Figure 3).

Be sure swivel casters with brakes are

mounted on same side as handle and fixed
casters are mounted parallel with long sides
of cabinet.

x 4

Swivel
Caster

Figure 3. Caster installed.

To remove and install drawers:

1. Fully extend drawer and remove contents.

2. Push left locking tab down and hold, then pull

right locking tab up and hold (see Figure 4).

Right Locking Tab

Left Locking Tab

Figure 4. Location of drawer locking tabs.

3. Pull drawer out.

4. Apply a thin layer of dry lubricant to drawer

slides.

5. Return tool cabinet to upright position.

Locking Drawers

Use the included key to lock the drawers. Only
completely closed drawers will lock.

5. To re-install, insert drawer runners into slides
and push drawer in until it stops. The lock­ing tabs will automatically snap into place to
secure the drawer in the slides.

Maintenance

• Use soft, clean cloth, and standard cleaning

solution to remove grease, dirt, or oil. Do not
use solvents or flammable cleaning liquids.

• Lubricate drawer slides as needed with dry

lubricant.

• Use graphite to lubricate lock annually.

-2-

T26902 14-Drawer Tool Chest (Mfd. 08/14)