Grizzly T26612 User guide

MODEL T26612 STAND

MACHINE/STAND

MOUNTING INSTRUCTIONS

For questions or help with this product contact Tech Support at [phone] or [e-mail]

Introduction

Figure 1. Model T26612 stand.

The Model T26612 stand is designed specifically
for the G0758 mill/drill or machines with bases
that have 8
layouts and fit inside of the tray. The stand is 31
tall with a 20
vides a stable surface for a machine.

1

⁄4" wide x 61⁄4" deep mounting hole

1

⁄2 " wide by 187⁄8" deep tray that pro-

1

⁄2 "

Local codes may require anchoring the stand to
the floor if the machine will be installed in a com­mercial or workplace setting, or if it is permanently
connected (hardwired) to the power supply.

If not required by any local codes, fastening the
stand to the floor is an optional step. If you choose
not to fasten the stand to floor, we recommend
placing it on machine mounts, as these provide an
easy method for leveling and they have vibration­absorbing pads.

Lag shield anchors with lag screws (see below)
are a popular way to anchor machinery to a con­crete floor, because the anchors sit flush with the
floor surface, making it easy to unbolt and move
the machine later. However, anytime local codes
apply, you MUST follow the anchoring methodol­ogy specified by the code.

Lag Screw

Flat Washer

Anchoring Stand to Floor

Number of Mounting Holes ............................ 4

Diameter of Mounting Hardware .................

(Hardware not included)

Anchoring the stand to the floor prevents machines
from tipping or shifting and reduces vibration that
may occur during operation, resulting in a machine
that runs slightly quieter and feels more solid.

COPYRIGHT © MAY, 2014 BY GRIZZLY INDUSTRIAL, INC.

NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

1

⁄2"

#DM16511 PRINTED IN CHINA

Stand Base

Concrete

Lag Shield Anchor

Drilled Hole

Figure 2. Popular method for anchoring

machinery to a concrete floor.

Mounting Machine to Stand

Machine Stand

M10-1.5 Hex Bolt

Welded On

Hex Nut

Flat Washer

Lock Washer

The Model T26612 stand comes with four mount­ing holes with M10-1.5 hex nuts welded on below
the mounting surface. Refer to Figure 3 for
mounting hole positions.

Viewed From Above

20½"

8¼"

187⁄8"

6¼"

Front of Stand

Use (4) M10-1.5 hex bolts, (4) 10mm lock washers,
and (4) 10mm flat washers to secure machine to
stand as illlustrated in Figure below. Each hex
bolt must extend at least a half inch below the
welded on hex nut.

Figure 4. Mounting hardware configuration.

Figure 3. Layout of machine mounting holes.