Grizzly H7861 User Manual

Introduction

These dual mini halogen lamps provide wide area illumination in indoor and outdoor environments.

Inventory (Figure 2)

1. Safety Screens (shown installed) ............... 2

2. Halogen Lamps .......................................... 2

3. Tripod ......................................................... 1

4. Mounting Arm ............................................. 1

Minor Components and Hardware

• Carriage Bolts M6-1 x 30 ...........................

• Threaded Knobs M6-1 ............................... 2

• Phillips Head Screws M4-.7 x 7 ................. 2

• Quartz Halogen Bulbs 500W ...................... 2

MODEL H7861

DUAL MINI HALOGEN

LAMPS W/STAND 500W

INSTRUCTION SHEET

Figure 1. Model H7861.

Note: Some components may already be pre-

assembled.

Assembly For Each Lamp

1. Unscrew the Phillips head screw holding the

lamp cover closed and open the lamp cover.

2. Install the safety screen by fitting the four safety screen lugs between the glass and the screen housing ( screen tab to the housing using an M4-.7 x 7 Phillips head screw.

3. Using a clean, dry cloth, gently install a 500W halogen bulb into the lamp socket. Close the housing and tighten the Phillips head screw.

Note: NEVER touch a halogen bulb with

bare skin! Oils in human skin can cause "hot spots" on the bulb, leading to drastically shortened bulb life.

4. Mount the lamp to the mounting arm using a threaded knob and an M6-1 x 30 carriage bolt.

Figure 3), and secure the

Figure 2. Model H7861 Inventory

Screen

Lugs

Screen

Tab

5. Seat the mounting arm in the tripod bracket and snap the spring lugs into place.

If you need help with your new halogen lamps, call our Tech Support at: (570) 546-9663.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#JK7970 PRINTED IN CHINA

Figure 3. Fitting locations of safety screen lugs.