Grizzly H6175 User Manual

1. Read and understand these instructions
before using this power mask.

2. This mask does not provide oxygen
Always follow the Permissible Exposure
Limit (PEL) guidelines set by OSHA .

3. Do not use in atmospheres immediately
dangerous to life or health.

Failure to heed these warnings may result in
sickness or death.

Model H6175 Half Face

Power Mask

.

Grizzly’s Model H6175 Half Face Power Mask
(shown in
protects against industrial contaminates.

To use the Half Face Power Mask:

1. Remove the mask and all components from

2. Unscrew the cartridge cover as shown in

3. Place a pre-filter on the outside of the car-

4. Twist on the cartridge cover.

5. Open the battery pack cover and install four

6. Plug the power cord into the battery pack.

7. Place the mask on your face and the plastic

Figure 1) facilitates easy breathing and

its container.

Figure 2.

tridge with the soft side to the air.

AA batteries (

head strap on your head.

Figure 3). Replace the cover.

Figure 1. Model H6175 Half Face Power Mask.

Figure 2. Cartridge cover removed.

Figure 3. Battery pack cover opened.

8. Adjust the mask to your face by tightening or

loosening the side straps (

Figure 4).

9. Clip the side straps together and turn the bat-

tery pack

ON.

10. To check for positive pressure, place your

hand over the exhalation valves and exhale
gently:
—If the mask bulges slightly and no leak is

detected, a proper fit has been obtained.

—If the mask leaks air, adjust the tension

of the elastic straps until a proper fit is
obtained and no air leaks are detected.

11. To check for negative pressure, place your

hand over the cartridge and inhale gently:
—If the mask pulls closer to your face with no

leaks between the mask and your face, a
proper fit has been obtained.

—If the mask does not pull closer to your

face, adjust the elastic straps until no air
leaks are detected.

Figure 4. Adjusting the side straps.

Maintenance:

Store the mask in a sealed (air tight) container to
increase the lifespan of the filter cartridges.

It is important to keep clean, functioning cartridg
es and filters in your power mask. Replace them if
they become damaged, soiled or when breathing
becomes difficult.

Always replace the cartridge and pre-filter with the
NIOSH approved Grizzly Model H6892 pre-filter
and Grizzly Model H6893 Filter Cartridge.

If you need additional help with this procedure,
call our service department at: [phone].

-

COPYRIGHT © JUNE, 2004 BY GRIZZLY INDUSTRIAL, INC.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#CA6382

PRINTED IN TAIWAN