Grizzly H5844 User Manual

UNITS OF MEASUREMENT

The range finder can display standard (feet) or metric (meters) units of measurement.

To toggle between the units of measurement displayed

, press the FEET/METER button.

TURNING RANGE FINDER ON/OFF

The range finder must be ON for all other functions to work.

To turn the range finder ON, press the MEASURE button once.

The range finder will automatically shut

OFF after

five minutes of no activity.

INSTRUCTION SHEET

Model H5844

60' Range Finder

The Model H5844 measures from the back end

of its case, so it can be placed against one

surface and accurately measure the surface

across from it.

3' 6"

The Model H5844 Range Finder.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#5953 PRINTED IN TAIWAN

LASER POINTER

The laser pointer shows which surface the range finder is using to calculate the distance.

To use the laser pointer, press the LASER button once.

WARNING—Laser radiation will damage eyes. Do not stare into beam or point beam at eyes.

Congratulations on your purchase! The Model H5844 is the perfect tool for speeding up large estimation projects. This instruction sheet will quickly familiarize you with your new range finder and its various functions.

MEASURE

FEET

METER

Laser

CLEARING DISPLAY & CLEARING STORED MEASUREMENTS

The ALL MEMORY CLEAR button has two functions, depending on how long the button is pressed.

To clear the display, press the ALL MEMORY CLEAR button briefly.

To clear all stored measurements from the memory

, press and hold the ALL MEMORY

CLEAR button for five seconds.

CALCULATING VOLUME

The range finder multiplies three stored measurements to quickly calculate a given volume.

To calculate the volume, store the length, height, and width in all three of the M

# buttons.

Press the VOL (volume) button and the range finder will automatically calculate the volume from the three measurements stored in the M

buttons.

CALCULATING AREA

The range finder multiplies two stored measurements to quickly calculate the square feet or square meters of a given area.

To determine the area, store the length and width in any of the three M

# buttons. Press the

AREA button, then press the two M

# buttons

where the length and width are stored.

ADDITION/SUBTRACTION

The range finder can add or subtract measurements that are stored in the memory with currently displayed measurements or other stored measurements.

To add (or subtract) two stored measurements

, recall the first measurement by

pressing the appropriate M

# button, then press

the “+” (or “-”) button, then recall the next measurement by pressing the other appropriate M

# button, then press the “+” (or “-”) key to show

the total of the added (subtracted) measurements.

STORING & RECALLING MEASUREMENTS

The range finder can store and recall measurements for the purpose of making calculations.

To store a measurement, take the measurement, press the STORE button, then press one of the M

# buttons (M1, M2, M3).

To recall a stored number, press the M# button that corresponds to the stored measurement you want to recall.

MEASURING DISTANCES

The range finder measures from the back end of its case to the object at which it is pointed (see illustration on previous page).

To take a measurement, position the back end of the range finder against the starting point and press the MEASURE button.

The range finder will beep once to acknowledge the button was pressed, then beep twice and display the measurement. Note—

The range finder works best when measuring surfaces at least 11

⁄4" (30 cm) wide.

If you need additional help with this item, call our service department at: (570) 546-9663.

MEASURE

AREA

VOL

MEASURE

STORE

M# M#

+ +

ALL

MEMORY

CLEAR

M# M#

– –