Grizzly H3103 User guide

Contact Info: [phone] or [e-mail]

#KS21459 Copyright © November, 2020 By Grizzly Industrial, Inc.

Introduction

The Model H3103 sharpens and polishes goug­es ½" to 2" wide using a tapered design with
aluminum-oxide construction. Made in Japan.

Box Contents (Figure 1)

Figure 1. Model H3103 Slip Stone.

Operating Slip Stone

1. For optimum performance, soak the Model

H3103 in cool, clean water for 5–8 minutes
prior to use (see Figure 2).

Note: Soaking in water removes residue

from previous sharpening, and provides
lubrication during each sharpening process.

MODEL H3103

CURVE GOUGE

SLIP STONE 1000 GRIT

INSTRUCTIONS

To reduce risk of eye injury, always wear
ANSI-approved safety glasses when
operating this tool.

Figure 2. Soaking slip stone in water.

To reduce risk of eye injury, always wear
ANSI-approved safety glasses when
operating this tool.

Use concave side of slip stone to sharpen

2.

gouge (see Figure 3).

Note: Always begin sharpening with a

coarse-grit stone before advancing to a
fine-grit.

Figure 3. Using concave side of slip stone to

Form a wire edge by repeating each stroke

3.

4. Use even strokes on convex side of slip

sharpen gouge bevel.

and alternating rotation direction until edge
is consistent across the entire gouge.

stone to remove wire edge on gouge bevel
(see Figure 4).

Figure 4. Using convex side of slip stone to

Verify wire edge is removed by testing

5.

gouge on a scrap workpiece.

Note: A properly sharpened gouge will

leave a smooth cut on workpiece surface.

Repeat Steps 4–5 as required.

6.

7. Polish edge of sharpened gouge with a

leather strop by rolling gouge from side-to­side while using even strokes.

remove wire edge.

Cleaning Slip Stone

1. Rinse slip stone under cool, clean water

after every use.

Storing Slip Stone

1. The Model H3103 should be stored in a

cool, dry area away from direct sunlight
after every use.