Taper Attachment for G4016
COPYRIGHT © AUGUST, 2004 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
6565
PRINTED IN CHINA
Deadman
....................................................
Vertical Shaft with cap screw M6x1.0 - 16
.
Cap Screws M8-1.25 x 30
Cap Screws M6-1.0 x 20
............................
Roll Pins
Washers 8mm
............................................
Washer 17mm
Avoid chlorine-based solvents and
Remove the splash guard from the back of
Remove the spacer, bearing dust cover and
Remove the two cap screws that hold the
for installation details.
Remove the nut that holds the bearings and
Remove the 6 philips head screws from the
Remove the end block and slide block from
Assemble the end block and bearing (
Install the bearing, spacer, and star washer
Thread the nut onto the end of the lead screw
Block
Hold the nut in place and bend one or more
Assemble the slide block to the end block
There are four threaded holes (See
Align the four holes in the main body with the
With the main body loosely fastened (see
The dovetail ways of the cross slide must
the main
/
Assemble the top cover plate, removed in
A support rod attaches the deadman to the
and
Adjust the position of the vertical shaft until
Re-attach the splash guard to the lathe and
Attach the deadman to the lathe bed (
The deadman is composed of a solid
There are two gib screws, for making adjust-
The gib is properly adjusted when the slide
Adjustments
If the gib is too loose, finish problems
Loosen the three nuts and apply tension
When satisfied with your results, tighten the
Re-attach the support rod to the main body.
Adjustments
To adjust the top gib, begin by removing the
Adjust the dovetail angle to zero.
Loading...