Grizzly G0625 User Manual
Introduction
The Model G0625 Extension Table extends the
bed length of the Model G0624 10" Benchtop
Lathe to 38" between centers.
MODEL G0625
BENCHTOP LATHE
EXTENSION TABLE
INSTRUCTION SHEET
Inventory: (Figure 1)
A. Extension Bed ............................................ 1
B. Rubber Feet ............................................... 2
C. Cap Screws M8-1.25 x 35 .......................... 4
D. Flat Washers 8mm ..................................... 4
E. Hex Wrench 6mm ...................................... 1
Installation:
1. Install the feet into the bottom of the exten-
sion table.
2. Align the mounting holes in the extension
table and the tailstock end of the Model
G0624 bed.
3. Thread four cap screws with flat washers
through the extension table and lathe, and
finger tighten.
4. Center the tailstock over the extension table
and lathe as shown in
5. Tighten the cap screws with the hex wrench,
to bring the bed extension and lathe surfaces
even with the bottom of the tailstock.
Figure 2.
A
B
C
E
D
Figure 1. Model G0625 inventory.
Extension
Table
Figure 2. Tailstock centered over extension
table and lathe.
Model
G0624
6. Slide the tailstock over the bed.
—If the tailstock catches on the area where
the lathe and extension table meet, loosen
the fasteners and repeat Steps 3-5
the tailstock slides smoothly.
COPYRIGHT © NOVEMBER, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
7. Place a straightedge over the extension table
and lathe beds and check to see if both are
parallel and aligned.
until
#BL8694 PRINTED IN CHINA
REF PART # DESCRIPTION
1 P0625001 BED EXTENSION
2 P0625002 RUBBER FOOT
3 PN08 HEX NUT 3/8-16
4 PW01M FLAT WASHER 8MM
5 PSB40M CAP SCREW M8-1.25 X 35
6 PAW06M HEX WRENCH 6MM
— If the extension table tilts down, use a
strip of masking tape along the bottom
edge of the lathe to shim the table up
(Figure 3).
Masking
Tape
Lathe
Masking
Lathe
Tape
Extension
Table
Figure 3. Shimming extension table up.
— If the extension table tilts up, use a strip
of masking tape along the top edge of the
lathe to shim the table down (
Figure 4).
— If the extension table is skewed to the left
or right, use a vertical strip of masking tape
along the corresponding edge of the
lathe
to make the extension table parallel with
the lathe (Figure
5).
G0625 Parts Breakdown and List
Extension
Table
Figure 4. Shimming table down.
Masking
Tape
Lathe
Extension
Table
Figure 5. Shimming table to the left.
Refer to the Model G0624 manual for instructions
on operating the lathe.
If you need help with your new extension table,
call our Tech Support at: (570) 546-9663.
Loading...