Griots garage G15, G21 User Manual

THE BOSS™ G15 & G21 R

Necessary tools and parts:

•

Replacement Rubber Shroud (G15 = Item# BGP11) (G21 = Item# BGP12)

•

Flat Trim Removal Tool or similar (non-metal) tool.

Included with your G15 or G21 Orbital:

•

Tube of Silicone Grease • 6mm Allen Wrench • Spacer Washer (for optional modification)

NOTE: We DO NOT RECOMMEND using a flathead screwdriver or any other metal item to remove the rubber shroud.
If a metal tool is used there is a high chance you may damage parts of your orbital.

uBBER SHROud REplacEmEnT

1.

Be sure the orbital is un-plugged. Gather the necessary
tools and contents of the shroud replacement kit.

2.

Using the 6mm Allen wrench, hold the backing plate with
one hand and unscrew the backing plate stud with the
wrench in a counter clockwise motion.

4.3.

Set the backing plate, stud, and lock washer to the side in a
safe place so they do not get lost.

www.griotsgarage.com • 800-345-5789

Using your hands, carefully pull the rubber shroud back
from the plastic housing and insert your trim removal tool
or pry tool here.

THE BOSS™ O

RBiTal SHROud REplacEmEnT

(c

OnT'd

.)

5.

With the trim removal tool placed between the rubber
shroud and plastic housing, carefully slide the trim tool
through the seam around the entire shroud, releasing it
from the housing.

6.

Inspect the old shroud for damage and discard.

8.7.

Once the old shroud is removed take the new rubber
shroud and locate the tabs around the inside of the shroud.

www.griotsgarage.com • 800-345-5789

Line one tab up with one of the notches in the plastic
housing on the orbital.