Griffin Technology SHARK 2 User Manual
2.0 manual for PC
Important Words
Congratulations and thanks for purchasing Griffin radio SHARK 2! Enjoy your new ability
to control how, where, and even when you listen to FM and AM radio.
There are two components to radio SHARK. The first is the Shark "fin," your USB-powered antenna.
The other part is the radio SHARK interface, a program that allows you to listen, record, and even
pause live FM and AM radio.
We have also included the very cool Snaptune One software as an optional program to use with your
radio SHARK, and further information on its use can be found on the Snaptune One section of this disc.
We advise against installing the Griffin radio SHARK software AND Snaptune One at the same time.
They both feature automatic scheduling, and could conflict with each other.
System Requirements:
- PC running Windows XP, Service Pack 2.
- Powered USB port.
www.griffintechnology.com
Get Up and Running Fast!
Interface Controls
Instant Recording
Scheduling a Recording
Saving and Listening to a Recording in iTunes
Burning the Recording
Exploring Your Options
Time Shift Recording
Troubleshooting
Griffin Technology Contact Info
4
5
6
7
8
9
10
11
12
13
Table of Contents
4
Get Up and Running Fast!
Follow these steps to perform a basic set-up of your radio SHARK hardware and software:
1. Install the radio SHARK software from the included CD-ROM and open the program. Or, install
Snaptune One instead, a program that is packed with features, like naming the songs you've
recorded and organizing them into playlists.
2. Plug the "fin" into a USB port on your computer. Use the included USB extension cable
to place the fin further away from your computer, which may improve your reception.
3. The software should immediately look for and recognize the attached radio SHARK hardware. You
may hear static, which means you're now free to tune in your favorite stations right at your computer.
4. Read on for instructions on the many things your radio SHARK can do!
Loading...