Griffin Technology H40R User Manual

www.Griffin-Stands.com

Remote Hi-Hat

Stand

www.Griffin-Stands.com

www.Griffin-Stands.com

Griffin™ stands and accessories are manufactured
in several innovative factories responsible for
developing products that address the newest

needs and trends of the current market. We take

pride in the Griffin™ brand and endeavor to be on
the forefront of the musical stands and musical
and lighting accessoriesmarket.

Performance Issue, Uneven or Unstable- Make

sure all nuts and bolts are tight on the product. If they
are, then loosen all nuts and bolts 1 full turn counter­clockwise, then go back and tighten each bolt only ½
turn tight. Then do a final tighten turn for another ½
turn tight. Next, Make sure there are not any missing
nuts or bolts. Third, ensure all parts on the product
are not broken or defective. Finally, Re-read the
assembly instructions or watch the product
demonstration video to ensure you have correctly
assembled or are using the product properly with
factory specifications.

Missing Parts- The pictures, videos and images

shown in this manual might have changed style or
count due to the product being redesigned. So in rare
cases the part may no longer be included or of a
different style. However, if you think you are missing
a part that is necessary to the assembly and use of
your product, then first carefully double check all
packaging for any parts you think are missing. Some
parts might be hiding in the packaging or loose in an
inner box.

User M an ua l

M od el # H4 0 R

Griffin | 11408 Hwy 64 W, Tyler, TX 75704 |

[e-mail] | www.Griffin-

Stands.com

For current product specifications, please to go

www.griffin-stands.com and type the model number

into the search bar. Locate the product listing to view
the current factory specifications.

Thank you for purchasing the Griffin Remote Hi-Hat
Stand. Your product comes with a 1 year factory
warranty from purchase date. Please read all
assembly instructions prior to assembling your new
cart. Pictures that may aid in assembly can be found
by going to www.griffin-stands.com and typing H40R
into the search bar.

Step 4 – For safety reasons, please always make
sure to test the stability and safety of the product
before use. Double check all nuts and bolts, knobs
and connectors, make sure that these are tight
and securely fastened before use of your product.
Test the product under light use or light loads the
first time to confirm assembly and structure of the
product is correct.

Step 1 – To set up, adjust the tension to your
preferred setting as seen on Figure 1. A higher
number represents a tighter tension, while a
lower number is of a lower tension.

Step 2 – Unscrew the top wing nut remove the
hi-hat clutch, place your bottom cymbal over
the cymbal seat and the top cymbal seat on the

hi-hat clutch. Place the whole assembly back

and adjust the hi-hat clutch to your preferred
distance over the bottom cymbals (See Figure 2
and 3) and tighten the wing nut. (See Figure 4)

Please scan the QR Code below for the product
demonstration video. Or go to the URL shown here and find
the product video. www.Griffin-Stands.com/Videos

Step 3 – On the hi-hat pedals there are 2 floor
spikes that can be screwed up and down to
prevent the pedal from slipping, to add grip to
the floor, screw it down on both side depending
on the floor and your preference as well.

Step 5 – Please note that an adaptor is needed to
attach this onto a stand, see Figure 5. Also make
sure that the cable is not tangled up and/or kinks
present during use. While this is designed to have
some curve in the cable, the cable inside the cable
housing must be able to move freely.