Components and Hardware List
Page 1 of 2
Bun Foot
A
4 pcs.
B
C D
5/16" Spring
Washer
5mm Allen
Wrench
E
1 pc.
8 pcs. 8 pcs. 8 pcs.
Made in Viet Nam
To prevent possible scratches
and damage, this furniture
should be assembled on a soft
surface such as a blanket or
carpet.
Step 1. Place the Night Stand
on its back. Attach the four
Bun Feet (A) to the bottom of
the Night Stand using the
Allen Head Bolts (B), Spring
Washers (C) and Flat
Washers (D). Tighten with
the Allen Wrench (E).
5/16"-18 x 2" Long
Allen-Head Bolt
5/16" x 19*2mm
Flat Washer
3-Drawer Night Stand
F
Anti-Tipping
Restraint Kit
1 pc.
Tipping Restraint Hardware Kit (F)
(Inside White Plastic Bag)
Bedroom
Assembly Instructions
Page 2 of 2
3. Firmly attach the other bracket onto a solid, structural part on the back of the furniture using the 5/8
inch long Wood Screws. It may also be necessary to pilot bore for these screws.
Approximately
2"
Install screws
through the small
hole in brackets
5/8 inch
Screw
5/8 inch
Screw
Wall Stud
Anti-Tip Hardware
Installation Instructions
Notice: This manufacturer recommends that steps be taken for certain furniture items toprevent
or minimize the risk of tip-over. This furniture is equipped with Tip-over Restraint Hardware for use
to minimize this risk, if used. Please follow below installation steps. This manufacturer recommends
that parents and guardians periodically visit the U.S. Consumer Product Safety Commission
(CPSC) website at http://www.cpsc.gov/ and stay up to date on all issues related tochildren's
product safety.
1. Temporarily locate the furniture to near it's final location in the room next to a wall. Locate a wall
stud behind your furniture and also mark the stud's location on the back of your furniture.
2. Firmly attach one bracket to the stud approximately 2" below the top of the furniture with the
2 inch long Wood Screws provided. It may be necessary to drill 3/32 dia. pilot holes for the screws.
4. Move the furniture into its final position, taking care to line up the wall bracket with the furniture
bracket. Thread a strap through the bracket as shown in the illustration. Tighten strap until snug
but do not over tighten.
Caution: This manufacturer assumes no liability for improper installation or excessive loads placed
on screws, brackets or straps. Failure to detach this restraint before moving furniture may result
in personal injury and property damage.
Warning: This tip-over restraint is not to be a substitute for proper adult supervision. Do not allow
children to climb on furniture. Items left on top of the TV and furniture, such as toys, remote
controls and treats might tempt young children to climb. Push the TV as far back as possible from
the front of its stand. Place electrical cords out of a child's reach, and teach children not to play with
the cords.
Loading...