Greenway Home Products MM284SOK, MM284SCH User Manual

ELECTRIC FIREPLACE
MANTEL

with hidden storage
compartments

MANTEAU DU FOYER
ÉLECTRIQUE

avec compartiments de
rangement cachés

REPISA DEL HOGAR
ELÉCTRICO

compartimientos escond
dos para almacenaje

Model / Modèle / Modelo: MM284SOK / MM284SCH

Assembly Instructions

Instructions d'assemblage

Instrucciones de ensamblado

TIPS FOR ASSEMBLY OF YOUR
NEW MANTEL

• Before you begin assembly, locate the instructions and hardware. Take out all the parts
and compare them to the diagrams below. Be sure you have all the parts and can identify them.

• A helping hand is always good: assemble your mantel with an adult assistant if possible. Some
pieces are heavy and will need to be held by a helper. Assembly time will be approximately
30-60 minutes.

• Locate a good Phillips-head screwdriver. You may also use an electric screwdriver but be careful not
to strip the head of the screw by over tightening them.

• After you assemble your mantel, if you find you have interference between the door and the hearth
please see Step 6 of these installation instructions for the solution.

NOTE: 284SOK = Oak Finish, 284SCH = Cherry Finish

TOP 1PC

284SOK.14/284SCH.14

RIGHT SIDE PANEL

(INTERIOR) 1PC

284SOK.05/284SCH.05

BACK PANEL 2PCS

284SOK.08/

284SCH.08

284SOK.01/284SCH.01

TOP SHELF 2PCS

284SOK.06/284SCH.06

LEFT DOOR 1PC

284SOK.12/

284SCH.12

BASE 1PC

BASE SHELF 2PCS

284SOK.07/284SCH.07

RIGHT DOOR 1PC

284SOK.13/

284SCH.13

LEFT SIDE PANEL

(EXTERIOR) 1PC

284SOK.02/284SCH.02

CENTER PANEL 1PC

284SOK.09/284SCH.09

SHELF 8PCS

284SOK.15/284SCH.15

1

RIGHT SIDE PANEL

(EXTERIOR) 1PC

284SOK.03/284SCH.03

LOWER CENTER

PANEL 1PC

284SOK.10/284SCH.10

1

LEFT SIDE PANEL

(INTERIOR) 1PC

284SOK.03/284SCH.03

FIREBOX SHELF 1PC

284SOK.11/284SCH.11

4

4

ANTI-TIP DEVICE 2 SETS

GET READY TO START

Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is red and located inside the packaging taped to the top box. Be sure you DO
NOT discard any pieces.

Step 1

Locate the hearth and place it on the floor. Do not put it up
against the wall at this point in the assembly as you need
to get in behind the mantel to insert several screws.

Step 2

Locate the 2 base shelves. Standing in front
of the hearth, place them with the finished side up on
the bottom of the left and right side hidden storage compartments.

Step 3

Locate the left inside and left outside wall panels,
the back panel and the top panel for the left
hidden storage compartment.

Locate the bag of plastic shelf supports. Insert 8
supports into the holes on the inside of both the
inside and outside wall panels.
NOTE: It is much easier to do this step before
you have built the hidden storage compartments.

Now position both the inside and outside wall
panels so that the bottom fits underneath the base
shelf. Slide the back panel (finished side inside the
compartment) between the side panels ensuring
that the back panel stays in position within the
grooves on both side panels. Get your helper to hold the panels snuggly in place while you insert
the 6 bottom screws which will hold the sides and back in position.

Position the top shelf in place. Ensure the compartment back is fitted into the groove on the top shelf.
Get your helper to apply pressure to the side to eliminate any gaps while you insert and tighten the
top 6 screws. You are now ready to insert the 4 shelves onto the shelf supports to complete the
storage compartment.

Step 4

Repeat Step 3, but with the right inside and right outside wall panels.