Greenway Home Products MM282ABL User Manual
ELECTRIC
FIREPLACE MANTEL
with integrated
sound system
MANTEAU DU FOYER
ÉLECTRIQUE
avec système
sonore intégré
REPISA DEL HOGAR
ELÉCTRICO
con sistema de
sonido integrado
Model / Modèle / Modelo: MM282ABL
Assembly Instructions
Instructions d'assemblage
Instrucciones de ensamblado
TIPS FOR ASSEMBLY OF YOUR
NEW MANTEL
• Before you begin assembly, locate the instructions and hardware. Take out all the parts and
compare them to the diagrams below. Be sure you have all the parts and can identify them.
• A helping hand is always good: assemble your mantel with an adult assistant if possible. Some
pieces are heavy and will need to be held by a helper. Assembly time will be approximately
30-60 minutes.
• Locate a good Phillips-head screwdriver. You may also use an electric screwdriver but be careful not
to strip the head of the screw by over tightening them.
TOP 1PC
ZZ.03.8001
FLAT HEAD SCREW
15PCS
BASE 1PC
ZZ.03.8000
CENTRAL PANEL 1PC
ZZ.03.8004
1
ZZ.03.8002
SUBWOOFER SHELF
ZZ.03.8005
1
ANTI-TIP DEVICE 2 SETS
4
LEFT LEG
1PC
RIGHT LEG
1PC
ZZ.03.8003
4
GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is red and located inside the packaging taped to the top box. Be sure you DO
NOT discard any pieces.
For the easiest assembly, use a power Phillips-head screwdriver. DO NOT over tighten the screws.
Step 1
Locate the hearth and place it on the floor. Do not put it up against
the wall at this point in the assembly as you need to get in behind
the mantel to insert several screws.
Step 2
Locate the left leg of the mantel. Facing the front of the hearth, take the
left leg, positioning it so the holes in the blocks on the legs line up with
the screw holes in the hearth. Insert the 1” screws into the smaller
screw holes and tighten.
Step 3
Locate the right leg of the mantel. Facing the front of the hearth, take the right leg, positioning it so the
holes in the blocks on the legs line up with the screw holes in the hearth. Insert the 1” screws into the
smaller screw holes and tighten.
Loading...