Greenway Home Products MM281CBL User Manual

ELECTRIC FIREPLACE
MANTEL

with convertible back
for corner option

MANTEAU DU FOYER
ÉLECTRIQUE

avec dos convertible pour
option de coin

REPISA DEL HOGAR
ELÉCTRICO

con parte posterior
convertible para la
opción de esquina

Model / Modèle / Modelo: MM281CBL

Assembly Instructions

Instructions d'assemblage

Instrucciones de ensamblado

TIPS FOR ASSEMBLY OF YOUR
NEW MANTEL

• Before you begin assembly, locate the instructions and hardware. Take out all the parts and
compare them to the diagrams below. Be sure you have all the parts and can identify them.

• A helping hand is always good: assemble your mantel with an adult assistant if possible. Some
pieces are heavy and will need to be held by a helper. Assembly time will be approximately
30-60 minutes.

• Locate a good Phillips-head screwdriver. You may also use an electric screwdriver but be careful not
to strip the head of the screw by over tightening them.

TOP 1PC

281CBL.07

RIGHT FRONT

PANEL 1PC

281CBL.05

RIGHT SIDE

PANEL 1PC

281CBL.04

FLAT HEAD SCREW

24PCS

BASE 1PC

281CBL.01

CENTRAL PANEL 1PC

281CBL.06

LEFT FRONT
PANEL 1PC

281CBL.03

LEFT SIDE

PANEL 1PC

281CBL.02

CORNER ATTACHMENT 1PC

281CBL.08

ANTI-TIP DEVICE 2 SETS

GET READY TO START

Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is red and located inside the packaging taped to the top box. Be sure you DO
NOT discard any pieces.
For the easiest assembly, use a power Phillips-head screwdriver. DO NOT over tighten the screws.

Step 1

Locate the hearth and place it on the floor. Do not put it up against
the wall at this point in the assembly as you need to get in behind
the mantel to insert several screws.

Step 2

Locate the left side panel and the left front panel. Facing the front of
the hearth, take the left side panel, positioning it so the holes in the
blocks on the bottom line up with the screw holes in the hearth.
Locate the left front panel and position it next to the left side panel,
lining up the holes in the blocks with the screw holes in the hearth.

Step 3

Repeat Step 2, but with the right side panel and the right front panel.

Step 4

Locate the header piece that will be attached to the left
and right legs and will sit above the firebox. Position the
header with the finished side facing the front of the
mantel. Insert and tighten the 4 screws which will hold
the header in place.