Greenway Home Products GEF257OK User Manual
Distinguished Electric Fireplace with 25” widescreen firebox
YEAR
ANNÉE
AÑO
1
I
N
-
H
O
M
E
W
A
R
R
A
N
T
Y
G
A
R
A
N
T
I
E
À
L
A
M
A
I
S
O
N
G
A
R
A
N
T
Í
A
E
N
S
U
P
R
O
P
I
A
C
A
S
A
Magnifique cheminée électrique à foyer grand écran de 25”
Magnifica chimenea con estufa eléctrica à pantalla ancha de 25”
Assembly Instructions
Instructions d'assemblage
Instrucciones de montaje
GEF257OK
REV00
TIPS FOR THE ASSEMBLY OF
YOUR NEW MANTEL
• Before you begin assembly, locate the instructions and hardware. Take out all the parts and
compare them to the diagrams below. Be sure you have all the parts and can identify them.
• A helping hand is always good. Assemble your mantel with an adult assistant if possible. Some
pieces are heavy and will need to be held by a helper. Assembly time will take approximately
30-60 minutes.
TOP 1PC
ZZ.257OK.09
BASE 1PC
ZZ.257OK.01
UPPER FACING
PANEL 1PC
ZZ.257OK.06
INSIDE
VIEW
LEFT FRONT
PANEL 1PC
ZZ.257OK.04
LEFT SIDE PANEL
1PC
ZZ.257OK.02
OUTSIDE
VIEW
RIGHT FRONT
PANEL 1PC
ZZ.257OK.05
RIGHTSIDE
PANEL 1PC
ZZ.257OK.03
21PCS 21PCS
LOWER FACING
PANEL 1PC
ZZ.257OK.07
2PCS 2PCS 4PCS 4PCS
FIREBOX SHELF
1PC
ZZ.257OK.08
4PCS
ANTI-TIP DEVICE 2 SETSWINGNUT AND LOCK WASHER
1
GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is
NOT discard any pieces.
Step 1
Locate the base and place it on the floor. DO NOT put it up against
the wall at this point in the assembly, as you need to get in behind
the mantel to insert several wingnuts, lock washers and firebox screws.
Step 2
Locate the left side panel and the left front panel. Facing the
front of the base, take the left side panel, positioning it so the holes
in the blocks on the bottom line up with the holes on the base. Position
the left front panel next to the left side panel, lining up the holes in the
blocks with the holes on the base. Attach the left front and side panel
to the base by inserting and tightening 1 wingnut and 1 lock washer
to each piece. Attach the left side and front panels together by
inserting and tightening 3 wingnuts and 3 lock washers.
RED and located inside the packaging, taped to the top box. Be sure you DO
Step 3
Repeat Step 2, but with the right side panel and the right
front panel.
2
Loading...