Greentel GT06 Quick Manual

- 1 -

GREENTEL

GPS Vehicle Tracker

Quick Guide

For GT06 Smart GPS Vehicle Tracker

- 2 -

1. Overview:

GT06

Accessory: power cable

Accessory: Relay

Accessory: Microphone

2. LED Indicators:

- 3 -

Red LED (power/working status)
LED Status Meaning

Flashing (interval 0.1s) Low battery indication
Continuously in bright state Charging
Slow Flashing (interval 0.2s) Full charge
Continuously in dark state Low battery/Power off
Slow Flashing (flash 0.1s after every 2s) Working normally

Blue LED (GPS status)
LED Status Meaning

Flashing (interval 0.1s) Searching GPS signal
Continuously in bright state GPS located
Continuously in dark state GPS not located

Green LED (GSM status indicator)
LED Status Meaning

Quick flashing GSM initialization
Slow Flashing (interval 0.2s) Receive GSM signal normally
Continuously in bright state GSM conversation/Start GPRS
Continuously in dark state No GSM signal

Ignition detection indication
Three (blue/red/green) LEDs are in cycling flashing.

3. Interface Introduction

4. Installation:

Preparation before installation:

- 4 -

A. Open the packing box to check whether the type of device is correct and whether the

accessories are included.

B. Please follow the following procedures to install your GT06. During installation, there

should be no power to the device.

C. Installing SIM card: each GT06 needs to insert a GSM SIM card. The SIM card should

activate GPRS service.

D. Testing SIM card: to test SIM card, please install it into a normal GSM mobile and

ensure it can send and receive SMS, and enables for GPRS.

E. Installing SIM card: remove the upper cover of device, insert SIM card as shown then

replace cover, lock the shell with 3 bolts.

F. Selecting installation place and fixing it. There are two kinds of installation: covert and

non covert. If you need the covert installation, please refer installation to an auto

electrical contractor.
Notice:
To prevent theft of the GT06, the device should be installed as covertly as possible.
Avoid placing the GT06 close to higher power electrical devices, such as reversing radar,
anti-theft device or other vehicle communication equipment;
The GT06 should be fixed into position with cable ties or wide double-side tape.
Your GT06 has built-in GSM antenna and GPS antenna. During installation, please make
sure the receiving side face is up, with no metal object above the device to interfere with
GPS reception.
The following places are suggested for installation:

- Under the dash board below the front windshield;

- In the parcel shelf in the rear;

- In the front bumper (non-material face), please ensure the device cannot get wet;

- Under the wiper version (non-metal), please ensure the device cannot get wet;

Notice: if the windshield is pasted with metal thermal-protective coating, it may affect the
performance of the device. In this case, please change the installation place after
consulting the professional.

G. Non Covert Installation,
Firstly fix the GT06 on the dash board below windshield

5. Device Wiring:

A. The standard voltage is 5V-36V, the red wire is the positive, and the black wire is the

negative.
B. Please connect the black wire to ground.
C. After connecting the power cord, run the power cord plug to the device. After

installation, supply power to device.
D. Covert installation: car battery cord is standard, with 2A FUSE for short-circuit over

current protection.