
Product Manual
JABIL Technology Services Design Services
Low Power ZigBee Module
(Ember)
TABLE OF AUTHORISATION
Name Role Organisation Signature
Thomas Chang PM PMO Thomas
Frank Liu Desing Manager R&D Frank
DOCUMENT HISTORY
Date Version
12/20/10 1.0 Draft Yao-Ling
Status Author Change
Initial Release
Cheng

TABLE OF CONTENTS
1 INTRODUCTION..........................................................................................................................................3
1.1
P
URPOSE
1.2
S
COPE
1.3
I
NTENDED AUDIENCE
1.4
D
EFINITIONS AND ABBREVIATIONS
2 OVERVIEW..................................................................................................................................................4
3 CONSTRAINTS, ASSUMPTIONS, AND DEPENDENCIES..................................................................5
4 FEATURES...................................................................................................................................................6
5 BLOCK DIAGRAM AND PORT FUNCTION ..........................................................................................7
5.1
UART P
5.2
P
ROGRAMMING AND DEBUG PORT
5.3
GPIO P
6 DETAIL SPECIFICATIONS ......................................................................................................................8
6.1
P
IN ASSIGNMENT
6.1.1 LPZigBee Module..........................................................................................................................8
6.2
E
LECTRICAL SPECIFICATION
6.2.1 DC power supply range ..............................................................................................................10
6.2.2 System dBm max & min (maximum and minimum TX output at PCB antenna) and
System current & power drawn................................................................................................................10
6.2.3 System current & power drawn of TX@20dBm and RX........................................................10
6.2.4 System Current and Power consumption during idle and deep sleep mode...................................10
6.2.5 System RX Sensitivity (dBm)...........................................................................................................11
..............................................................................................................................................3
...................................................................................................................................................3
............................................................................................................................3
........................................................................................................3
ORT
.........................................................................................................................................7
.......................................................................................................7
ORT
..........................................................................................................................................7
...................................................................................................................................8
................................................................................................................10

1 INTRODUCTION
1.1 P
The purpose of this document is to provide the product manual and Design
Specifications for low power ZigBee
1.2 S
The scope of this document is to produce the detail Design of LPZigBee module.
1.3 I
This document is intended primarily for the EE Hardware Design.
1.4 D
Term Meaning
ADC Analog to Digital Converter
GPIO General Purpose Input/Output
I2C Inter Integrated Circuit
JTAG Joint Test Action Group
FEM Front-end module
SPI Serial Peripheral Interface
UART Universal Asynchronous Receiver Transmitter
NF Noise figure
LPZigBee Low power ZigBee Module
URPOSE
COPE
NTENDED AUDIENCE
EFINITIONS AND ABBREVIATIONS
(LPZigBee)
module.

2 OVERVIEW
LPZigBee module mainly consists of two sections: The System-on-Chip (EM357) and
the RF front-end (SE2432L) with power amplifier and low-pass filtering.
The EM357 includes radio transceiver and microcontroller. The radio transceiver
handles all actions concerning RF modulation/demodulation, signal processing, frame
reception and transmission. MAC hardware acceleration functions are implemented
in the radio transceiver, too. Further information about the radio transceiver and the
microcontroller are available in the appropriate datasheets, refer to 1.5 references.
The RF front-end incorporates signal amplification and filtering of the transmit signal.
The degree of filtering depends on operating conditions as well as regional aspects.
Switching between reception and transmission is directly controlled by the radio
transceiver.