green-i GIMB Product Manual

Overview

The GIMB miniature PIR (passive infrared) presence
detector provides automatic control of lighting loads. It is
specifically designed for mounting onto a batten style
luminaire.

The detector will switch incandescent, fluorescent, compact
fluorescent and LED lighting.

The unit detects movement using a PIR sensor and turns
the load on. When an area is no longer occupied the load
will switch off after a 10 minute time out period.

A selection of fixing washers are supplied to aid fixing to a
variety of luminaires.

Batten mount PIR detector

GIMB
Product Guide

Detection diagram

Walk towards Walk across

Height Range Diameter

7m 10m

2.8m 5m

Height Range Diameter

7m 16m

2.8m 9m

Note: illustration shows an average of the walk across and walk towards figures below.

2

Installation

Components

Standard luminaire fitting

IP luminaire fitting

Part Quantity

Supplied

IP Spacer with silicone coating 1

Silicone washer 1

5º washer 1

5º spacer 1

M20 nut 1

Mounting hole without key

Mounting hole with key

Note. Key to be at top of
sensor.

Note. Use the 5º spacers
where the luminaire
housing has a draft angle.

Important
Ensure that the Silicone washer and/or the IP spacer are used to ensure IP rating.

Do not grip unit at the lens end. Hold the square body near the threaded end when installing and tightening the
nut. Care must be taken to prevent damage to the lens and surrounding IP seal.