Greenheck EDD-401 User Manual
Specialty Louver Shapes
GREENHECK
AB DCEF
Shape
Qty. Model
Size
Options
WHH
1
Project:
Contractor:
Location:
Design Specifier:
H
W
H
H1
W
H1
H
W
H
WD W W
H
H
RA RB RC RD RE RF RG
Circular & Semicircular
Dampers & Louvers
Specialty shapes are available in louver
model and blade design listed below.
See the louver model submittal sheet
for the blade shape detail.
Models
ESJ-202
ESJ-401
ESK-402
ESD-403
EDD-401
ESJ-602
ESK-602
ESD-603
EDD-601
Special shaped louvers are not AMCA
tested for water penetration and air flow
resistance. Conservative air flows
should be used when sizing louvers to
help prevent water carry over.
Stationary Extruded Aluminum
Standard Construction
Frame: Heavy gauge 6063T5 extruded aluminum
Blades: Heavy gauge 6063T5 extruded
aluminum positioned at 45° angles
Birdscreen: 3⁄4" x .051" flattened expanded aluminum.
Screen is mounted on inside (rear)
Finish: Mill
Minimum Size: 20" Diameter. Consult Greenheck
if smaller sizes are required.
Options (at additional cost)
• Flanged frame
• A variety of bird and insect screens
• A variety of architectural finishes including:
Clear anodize
Integral color anodize
Baked enamel
Kynar
• 0.125" nominal wall thickness
W & H Dimensions furnished approximately 1⁄4" under size.
*
Cir. Dec. 1997
Specialty Louver Shapes
GREENHECK
AB DCEF
Shape
Qty. Model
Size
Options
WHH
1
Project:
Contractor:
Location:
Design Specifier:
H
W
Triangular
Dampers & Louvers
TA TB TC TE
H
H1
H
HH
WW W W
Standard Construction
Specialty shapes are available in louver
model and blade design listed below.
See the louver model submittal sheet
for the blade shape detail.
Models
ESJ-202
ESJ-401
ESK-402
ESD-403
EDD-401
ESJ-602
ESK-602
ESD-603
EDD-601
Special shaped louvers are not AMCA
tested for water penetration and air flow
resistance. Conservative air flows
should be used when sizing louvers to
help prevent water carry over.
W & H Dimensions furnished approximately 1⁄4" under size.
*
Typical Frame
Typical Sill
Frame: Heavy gauge 6063T5 extruded aluminum
Blades: Heavy gauge 6063T5 extruded
Birdscreen: 3⁄4" x .051" flattened expanded aluminum.
Finish: Mill
Options (at additional cost)
Stationary Extruded Aluminum
TF TG
H
H1
W
aluminum positioned at 45° angles
Screen is mounted on inside (rear)
• Flanged frame
• A variety of bird and insect screens
• A variety of architectural finishes including:
Clear anodize
Integral color anodize
Baked enamel
Kynar
• 0.125" nominal wall thickness
W
H
H1
Tri. Dec. 1997
Loading...