GreenGuard Sill Sealer User Manual
1-800-241-4402 www.green-guard.com
Sill Sealer
INSTALLATION GUIDELINES
1. Finish foundation according to applicable building
codes and remove all points greater than 1/4" tall.
2. Sweep any debris from foundation surface.
3. Unroll GreenGuard Sill Sealer across the top of the
foundation wall, making sure it is flush with the face
of the wall.
Or
For tilt wall construction, staple GreenGuard Sill
Sealer to the bottom of the sill plate.
4. Make sure the corrugated side of GreenGuard Sill
Sealer is facing the most irregular surface.
5. Butt all end and perpendicular joints tightly; do
not overlap.
6. Impale GreenGuard Sill Sealer to fit over anchor bolts.
7. Set sill plate on the top of the foundation wall and
anchor securely. Continue construction.
Compliance—Sill Sealer complies with all relevant building
codes. For the most current compliance information,
go to green-guard.com.
GreenGuard®Disclaimers
• WARNING: Foam plastic insulation will ignite if exposed to fire of sufficient heat
and intensity. Protect foam insulation from exposure to open flame or other
ignition sources during shipping, storage, and installation.
• Pactiv Building Products believes the information and recommendations herein to
be accurate and reliable. However, since use conditions are not within its control,
Pactiv Building Products does not guarantee results from use of such products or
other information herein and disclaims all liability from any resulting damage or
loss. NO WARRANTY, EXPRESS OR IMPLIED, IS GIVEN AS TO THE
MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, OR OTHERWISE
WITH RESPECT TO THE PRODUCTS REFERRED TO.
• For more information on specific building product recommendations and
installation guidelines, contact your Pactiv Building Products insulation
representative.
GreenGuard is a registered trademark of Pactiv Building Products.
© 2005 Pactiv Building Products, 4/05.
INSTL-SILL
Sill Sealer
Foundation Wall
Sill Plate
Framing Members
Anchor Bolts
Loading...