GreenGuard Fanfold Siding Underlayment User Manual

GreenGuard® Fanfold Underlayment Installation Guide
Verify that substrate is at, dry, and free of foreign material that will damage the GreenGuard® Fanfold Underlayment. Beginning of installation means installer accepts the existing conditions.
A.
B.
C.
Install GreenGuard® Fanfold Underlayments directly over old siding using galvanized or alu­minum roong nails, with nails spaced about 2 feet apart. If the existing siding is damaged, remove it and install GreenGuard® Fanfold Underlayment directly to the substrate.
Install the new siding material over GreenGuard® Fanfold Underlayment in accordance with the
siding manufacturer’s installation instructions.
Care should be taken when installing GreenGuard® Fanfold Underlayment under siding materials. These products must be adequately fastened so that the entire board lays
For the most current product and code compliance information, go to www.TrustGreenGuard.com
Warning: Foam plastic insulation will ignite if exposed to re of sufcient heat and intensity. Protect foam insulation from
exposure to open ame or other ignition sources during shipment, storage, and installation.
Storage and Handling: When stored outdoors, all materials should be protected from exposure to direct sunlight using an
opaque light-colored tarp or the original packaging. Material that has been unwrapped should be carefully rewrapped.
Pactiv Building Products believes the information and recommendations herein to be accurate and reliable. However, since use conditions are not within its control, Pactiv does not guarantee results from use of such products or other information herein and disclaims all liability from any resulting damage or loss. NO WARRANTY, EXPRESS OR IMPLIED, IS GIVEN AS TO THE MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, OR OTHERWISE WITH RESPECT TO THE PRODUCTS REFERRED TO.
GreenGuard® is a registered trademark of Pactiv LLC.
©2014 Pactiv LLC. 1/14 INSTL-FFUL
1-800-241-4402 www.TrustGreenGuard.com
Loading...