WEATHERPROOF PROTECTION
IP44
WEATHERPROOF
SWITCHES
• Simple to install
• Designed for damp, dusty and dirty
environments
• Rated to IP44
• Conforms to BS EN 60529
These GreenBrook Weatherproof
Switches are designed specifically for
use where damp or dusty conditions
may be encountered.
Engineered to perform in dirty environments, in industry, farms, gardens,
beside swimming pools, indeed wherever exposure to dust or splashing
water may be encountered.
These tough, durable items are easily
installed. The switches are protected to
IP44 standard. The units are injection
moulded in polycarbonate ensuring
high resistance to impact in extremes
of temperature.
1. This product should be installed by
a competent person (e.g. qualified
electrician) in accordance with these
instructions and in compliance with
the appropriate clauses of the
current edition of the IEE Wiring
Regulations.
2. The electrical supply must be
disconnected prior to installation or
maintenance.
3. Where metal conduit is used, earth
continuity must be maintained with
the use of a suitable earth link.
SAFETY
INSTALLATION
GUIDE
STEP 1.
WARRANTY BECOMES INVALID IF I.P.
RATING IS NOT MAINTAINED.
1. The mounting surface must be flat
MODEL NUMBERS:
WNBP-C,
WNSW-C, WNSW2G-C & WNSWDP-C
PLEASE KEEP THESE
INSTRUCTIONS SAFE
FOR FUTURE REFERENCE
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
E. sa l es@gr e enbroo k .co.u k
W W W. G R E E N B R O O K . C O . U K
Issue No: 701451
and free from grease, dirt or loose
material.
2. Ascertain the required position for
the unit. Remove rocker switch plate
(grey) by inserting a small flat
bladed screwdriver either side of the
switch and lever off. Unscrew the 2
s
crews and remove the switch cover
thereby exposing the switch module.
Remove the switch module by
pulling firmly.
3. Using the pre-drilled holes in the
base unit, screw the base unit into
the required position.
4. 20mm compression glands for cable
entry to switch units should be used
to maintain IP rating.
5. These switches have screwless
terminals and are intended for use
with solid conductors.
NOTE: These switches use screwless
terminals
6. Strip back 13mm of insulation from
each wire and push lengths fully into
appropriate terminals. Ensure earth
conductor is sleeved with green /
yellow sleeving and secured to the
earth terminal.
7. Once the unit has been wired, re-fit
the switch module to the base unit
and re-secure the switch cover.
Tighten with the 2 screws.
8. Push rocker switch plate (grey) back
into position ensuring correct
orientation.
9. Do not use solvents or acids to
clean the box as these may attack
the plastic used. The exterior should
be cleaned only by using a mild
solution of detergent and warm
water.
WARNING
DISCONNECT THE MAINS SUPPLY
BEFORE COMMENCING ANY WORK
Loading...