Page 1
Installation Instructions
for LED Outdoor Bulkhead
ight Fitting
L
Model Number: LEDPOLYP
SAFETY INFORMATION
Important Safety Instructions
• Please read these instructions
carefully before installation and
keep safe for future reference.
IMPORTANT
This product should be installed by
a competent person and in
accordance with the current IET
Wiring Regulations. If in doubt,
consult a qualified electrician.
• Always turn off the mains supply
before commencing work.
• This appliance must not be earthed.
• Before installation or maintenance,
ensure that the mains supply to the
luminaire is switched off and the
circuit supply fuses are removed or
circuit breaker turned off.
INSTALLATION INSTRUCTIONS
1. Switch off mains supply before
installation.
2. Remove the diffuser from the base
by releasing the two captive
retaining screws.
3. Remove the LED module tray from
base by releasing captive screws and
unplug the DC connection to the
LED driver.
4. Select a suitable cable entry point
and carefully remove the appropriate
knock-out(s). Place the base on a
firm surface and using a suitable
punch, strike sharply on the knockout near the inside mark.
5. Position and fix the base to a
suitable solid surface using the
screws supplied, rubber washers or
sealant should be applied around
the screw heads to reduce water
ingress if the luminaire is to be
mounted externally.
6. Fit the supply cable into the
luminaire through a previously
selected hole ensuring that a cable
gland, grommet or sealing
compound is used to maintain the
IP rating of the luminaire.
NOTE: To maintain IP rating and
weatherproof, a suitable
gasket (rubber) should be fitted
when mounting on a BESA conduit
box - fitted by M4 screws through
holes provided on rear of fitting.
Page 2
7. Terminate the cable into the
terminal block mounted on the
base, ensuring correct polarity is
bserved.
o
8. Connect the plug to the LED board
and re-fit it on the base.
9. Re-fit the diffuser, do not over-
tighten the screws.
0. Switch on mains power to test the
1
luminaire.
TECHNICAL DATA
Input Voltage: 230V 50Hz
Rating: IP65
Power Consumption 6W
Light out: 420 Lumens
Colour Temp: 4000K
LED Qty: 32pcs SMD LED
This luminaire is of class II construction
GUARANTEE
Your KingShield LED Outdoor Bulkhead
Light Fitting is guaranteed for 3 years
from the date of purchase.
This is in addition to your
statutory rights.
PLEASE KEEP THESE INSTRUCTIONS SAFE
FOR FUTURE REFERENCE
Issue no: 703957
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
sa les@ gree nbroo k.co .uk
W W W. G R EE N B R O OK . C O . UK
Loading...