Gree Electric Appliances of Zhuhai LYMF 01 User Manual

Caution:The user is cautioned that changes or modifications not
expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules and Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.

NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device,pursuant to Part 15 of the FCC
Rules.These limits are designed to provide reasonable protection
against harmful interference in a residential installation.This
equipment generates, usesand can radiate radio frequency energy
and, if not installedand used in accordance with the instructions,may
cause harmful interference to radio communications.However, there
is no guarantee that interference will not occur in a particular
installation.

If this equipment does cause harmfulinterference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

FCC& IC Radiation Exposure Statement:
This equipment complies with FCC and Canada radiation exposure
limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.

Déclaration d’IC sur l’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux radiations
définies par le Canada pour des environnements non contrôlés.
Cet émetteur ne doit pas être installé au même endroit ni utilisé avec
une autre antenne ou un autre émetteur.

PRODUCT INTRODUCTION

01

GREE Cube Controller is an infrared remote controller

that can operate the air conditioner. There are different

functions on six sides. It can be linked to the mobile

phone through Bluetooth and configure functional

parameters of the air conditioner. You can quickly enable

personal modes by turning or rotating it after configuration.

It also supports child lock and search function.

PRODUCT DESCRIPTION

01

02

① ⑤

② ⑥ ⑦

③ ④

Indicator light

Battery cover

Plectrum to open cover

Battery

Built-in buzzer

Cover groove

Reset button

FUNCTION INTRODUCTION

03

Diagram of GREE Cube Controller

“ ”This mode can be personalized on the App

SLEEP

When “SLEEP” is on the top，sleep mode is set.
Default: cool, 27℃，auto fan, swing up and down,no swing around,
no timing function, traditional sleep mode.

FUNCTION INTRODUCTION

03

When “Personal 2” is on the top, personal mode is set.
Default: cool, 20℃，auto fan,swing up and down , swing left and
right.

Personal 2

Personal 1

When “Personal 1” is on the top, personal mode is set.
Default: cool, 26℃，auto fan, swing up and down, no swing left
and right.

AUTO

When “AUTO” is on the top, AUTO mode is set.
Default: auto fan, swing up and down, swing left and right
(SLEEP mode is turned off).

GREE on Top (temperature control)

Only the “GREE” side can be rotated. When “GREE” is on the
top, rotate GREE Cube Controller 60°clockwise in one second to
increase set temperature by 1℃; rotate the cube counterclockwise
to decrease set temperature by 1℃. (Unavailable in AUTO mode)

Blank side (Shutdown)

When the blank side is on the top, the air conditioner is turned off.

OPERATION INSTRUCTION

04

① Function Switch ③ Shutdown

Turn 90°to switch mode.

② Temperature adjustment

When battery power is low, indicator
light flashes twice and buzzer rings
once to remind user to replace battery.

Turn to the blank side to

turn off the air conditioner.

④ Low-power indicator

When battery-power is low, indicator
light flashes twice and buzzer rings
once to remind user to replace battery.

GREE CUBE CONTROLLER

Gree Electric Appliances, Inc. of Zhuhai

Address: Jinji west road,Qianshan, Zhuhai,
Guangdong province.
Post Code: 519070
Customer Service Hotline: [phone]

Model: LYMF-02

Printing Date:

Version Number:01

FUNCTION TIPS

05

If battery power is normal, the indicator light will be on for 2s. If battery power
is low, the indicator light will not go on.
If battery power is normal, the indicator light will be on when GREE Cube
Controller is connected to the mobile phone and go out once it is disconnected
from the phone.
If battery power is normal, the indicator light will flash once after an infrared
control command is given.
If battery voltage is low, the indicator light will flash twice and then stop.

If battery power is normal, buzzer will ring for 1s. If battery power is low, buzzer
won’t respond.
If battery voltage is low, buzzer will ring once and then stop.
If child lock function is turned on, buzzer will ring twice when operating on the
locked side.
When the search function is turned on, buzzer will ring intermittently for 1min.
If the search function stops, buzzer will stop ringing.

Indicator light

Buzzer

Reset button

There is a reset button at the blank side of the cube. Press and hold the reset
button for 3s and the buzzer will ring once, which means the cube resumes its
initial setting.
If you want to unbind the cube with GREE+ APP, open the APP and choose the
corresponding Cube Controller. Tap the button “Unbind”. Then press and hold
the reset button for 3s to unbind the cube. When the cube resumes its initial
setting, you can bind a new user.

NETWORK CONNECTION

06

“GREE+”APP

Open “GREE+App”,log in or register an account;

After successfully logging in, tap “+” in the upper right corner,

open Bluetooth and add a smart device. Select a cube model,

and then you can use it after successful connection.

Note: The air conditioner cannot be controlled when the cube

is connected to the APP.

PARAMETER LIST

07

Magic Cube Controller(size) 54×54×54（mm）

Magic Cube Controller(weight)

Power supply way

Communication

Battery life

95g（including battery）

Two no.7 batteries

Bluetooth 5.0 BLE

Battery life is related to various factors such

as setting, operation and use environment in

practical use. Normally, the lifetime of the

batteries is longer than half a year. Extreme

use can shorten time.

COMMON FAULT HANDLING

08

Fault description

Indicator light

does not work

APP can't

find device

APP can't

connect to

the cube

Beyond the

search scope

Fault causes

Bluetooth not turned on

Out of Bluetooth
communication range

Bluetooth not turned on

Out of Bluetooth

communication range

Bluetooth not turned on

GREE Cube Controller is

bound with another device

Out of Bluetooth

communication range

Battery in low power

Beyond the search scope

Solutions

Install battery correctly

Replace battery

Turn on Bluetooth

Operate in Bluetooth

communication range

Turn on Bluetooth

Operate again after unbindingIn

Bluetooth communication

Operate in Bluetooth

communication range

Replace the battery

Operate in Bluetooth

communication range

THINGS TO BE NOTED

09

When the surface of the cube is stained with dust, wipe it clean with a
fine cloth.Avoid using corrosive cleaning fluid or other chemical solvents.

Avoid impact, knock or strong vibration to prevent the cube from
cracking or damage to the internal structure.

Install batteries before use. Pay attention to the positive and negative
electrodes to prevent reversed installation.
Do not mix new and old as well as different types of batteries together
for operation.
When the unit is not used for a long time, please take out the batteries
prevent damaging the remote controller by liquid leakage.

GREE Cube Controller can save data locally. Configuration information
will not be lost after power failure.

Be sure to contact our customer service when GREE Cube Controller
breaks down. Non-professionals should not dismantle it.

PLECTRUM TO OPEN COVER

10

Put plectrum into the groove and pry the bottom cover.

Plectrum sticks here.

CERTIFICATE

11

01

Name:＿＿＿＿ Type:＿＿＿＿　No:＿＿＿＿＿＿

Date:＿＿＿＿＿＿＿ Inspector:＿＿＿＿＿＿＿

GREE ELECTRIC APPLIANCES,INC,OF ZHUHAI

STATEMENT ON HARMFUL

12

01

SUBSTANCES

Content of harmful substances

Components Name

Controller and
electrical components

Sponge

Other plastic
parts

Other metal
parts

Other packages and
printing materials

○: It represents that the contents of the harmful substance among all the homogeneous

materials of the component are below the limited requirements specified in GB/T 26572.

×: It represents that at least one certain content of the homogeneous materials of the harmful

substance has exceeded the limited requirements specified in GB/T 26572.For the “X” part of
the above table, due to technical reasons, it has no replacement at present, but will be improved
with technical advancement.

“Environmental protection service life” of this product is 10 years and
we indicate the term according to the design characteristic of the product.
Only when using the product under the normal situation specified in the
user manual is the “Environmental protection service life” effective.

Harmful substances

(Pb) (Hg) (Cd) (Cr(VI)) (PBB) (PBDE)

○ ○ ○ ○

×

○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○

○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○

○

GREE CUBE CONTROLLER