Gree GMV-ND36A/A-T, GMV-ND24A/A-TU, GMV-ND42A/A-T, GMV-ND36A/A-TU, GMV-ND42A/A-TU Owner's Manual
...
AIR CONDITIONER
INDOOR UNIT
Owner's Manual
Original Instructions
Commercial Air Conditioners
GMV DC Air Handler
Models:
GMV-ND24A/A-T(U)
GMV-ND30A/A-T(U)
GMV-ND36A/A-T(U)
GMV-ND42A/A-T(U)
GMV-ND48A/A-T(U)
GMV-ND54A/A-T(U)
Preface
For correct installation and operation, please read all instructions carefully. Before
reading the instructions, please be aware of the following items:
(1) For the safe operation of this unit, please read and follow the instructions carefully.
(2) During operation, total capacity of indoor units should not exceed the total capacity
of outdoor units. Otherwise, poor effect of cooling or heating may result.
(3) Direct operators or maintainers should well keep this manual.
(4) If this unit fails to operate normally, please contact our service center as soon as
possible and provide the following information:
● Content on the nameplate(model number, cooling capacity, production code,
ex-factory date).
● Malfunction details(before and after the malfunction occurs).
(5) Each unit has been strictly tested and proved to be qualified before ex-factory. In
order to prevent units from being damaged or operating normally because of improper
disassembly, please do not disassemble the unit by yourself. If you need to disassemble
and check units, please contact our service center. We will send specialists to guide the
disassembly.
(6) All graphics in this manual is only for your reference. For sales or production
reasons, these graphics are subject to change by manufacturer without prior notice.
User Notice
● This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.Children should be supervised to ensure that they do not play
with the appliance.
Correct Disposal of this product
This marking indicates that this product should not be disposed with
other household wastes. To prevent possible harm to the environment
or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They can take
this product for environmental safe recycling.
Contents
1 Safety Precautions .............................................................................................. 1
2 Product Introduction ............................................................................................ 3
2.1 Names of Key Components ..................................................................................... 3
2.2 Rated Working Condition ......................................................................................... 3
3 Preparative for Installation ................................................................................... 4
3.1 Pre-Installation Instruction ........................................................................................ 4
3.2 Important Safety Instructions .................................................................................... 4
3.3 Requirements for Communication Line .................................................................... 6
3.4 Wiring Requirements ................................................................................................ 7
4 Installation Instructions ........................................................................................ 8
4.1 Dimension Data ....................................................................................................... 8
4.2 Location ................................................................................................................... 9
4.3 Piping Work ............................................................................................................ 10
4.4 Condensate Removal ............................................................................................. 11
4.5 Ductwork ................................................................................................................ 11
4.6 Installation of Wired Controller ............................................................................... 12
5 Wiring Work ....................................................................................................... 12
5.1 Connection of Wire and Patch Board Terminal ....................................................... 12
5.2 Power Cord Connection ......................................................................................... 13
5.3 Connection of Communication Wire between Indoor Unit and Outdoor Unit (or indoor
unit) .............................................................................................................................. 13
5.4 Connect Communication Wire of Wired Controller ................................................. 14
5.5 Illuminate for Connection of Wired Controller and Indoor Units Network ................ 15
6 Routine Maintenance ......................................................................................... 17
6.1 Cleaning of Filter .................................................................................................... 17
6.2 Maintenance before the Seasonal Use ................................................................... 17
6.3 Maintenance after the Seasonal Use ...................................................................... 17
7 Table of Error Codes for Indoor Unit .................................................................. 18
8 Troubleshooting ................................................................................................. 18
GMV DC Inverter VRF
1
1 Safety Precautions
WARNING
(1) Follow this instruction to complete the installation work. Please carefully read this manual before unit
startup and service.
(2) Wire size of power cord should be large enough.The damaged power cord and connection wire should be
replaced by exclusive cable.
(3) After connecting the power cord, please fix the electric box cover properly in order to avoid accident.
(4) Never fail to comply with the nitrigen charge requirements.Charge nitrogen when welding pipes.
(5) Never short-circiut or cancel the pressure switch to prevent unit damage.
(6) Please firstly connect the wired controller before energization, otherwise wired controller can not be used.
(7) Before using the unit, please check if the piping and wiring are correct to avoid water leakage, refrigerant
leakage, electric shock, or fire etc..
(8) Do not insert fingers or objects into air outlet/inlet grille.
(9) Open the door and window and keep good ventilation in the room to avoid oxygen deficit when the gas/oil
supplied heating equipment is used.
(10) Never start up or shut off the air conditioner by means of directly plug or unplug the power cord.
(11) Turn off the unit after it runs at least five minutes; otherwise it will influence oil return of the compressor.
(12) Do not allow children operate this unit.
(13) Do not operate this unit with wet hands.
(14) Turn off the unit or cut off the power supply before cleaning the unit, otherwise electric shock or injury
may happen.
(15) Never spray or flush water towards unit, otherwise malfunction or electric shock may happen.
(16) Do not expose the unit to the moist or corrosive circumstances.
(17) Under cooling mode, please don't set the room temperature too low and keep the temperature difference
between indoor and outdoor unit within 5℃ (41℉).
(18) User is not allowed to repair the unit. Fault service may cause electric shock or fire accidents. Please
contact Gree appointed service center for help.
(19) Before installation, please check if the power supply is in accordance with the requirements specified on the
nameplate. And also take care of the power safety.
(20) Installation should be conducted by dealer or qualified personnel. Please do not attempt to install the unit by
yourself. Improper handling may result in water leakage, electric shock or fire disaster etc..
GMV DC Inverter VRF
2
(21) Be sure to use the exclusive accessory and part to prevent the water leakage, electric shock and fire
accidents.
(22) Make sure the unit can be earthed properly and soundly after plugging into the socket so as to avoid
electric shock. Please do not connect the ground wire to gas pipe, water pipe, lightning rod or telephone line.
(23) Electrify the unit 8 hours before operation. Please switch on for 8 hours before operation. Do not cut off the
power when 24 hours short-time halting (to protect the compressor).
(24) If refrigerant leakage happens during installation, please ventilate immediately. Poisonous gas will emerge if
the refrigerant gas meets fire.
(25) Volatile liquid, such as diluent or gas will damage the unit appearance.Only use soft cloth with a little neutral
detergent to clean the outer casing of unit.
(26) If anything abnormal happens (such as burning smell), please power off the unit and cut off the main power
supply, and then immerdiately contact Gree appointed service center.If abnormality keeps going, the unit
might be damaged and lead to electric shock or fire.
Any personal injury or property loss caused by improper installation, improper debug,
unnecessary repair or not following the instructions of this manual should not be the
responsibility of Gree Electric Appliances, Inc. of Zhuhai.
GMV DC Inverter VRF
3
2 Product Introduction
2.1 Names of Key Components
Fig 2.1
2.2 Rated Working Condition
Indoor Side Condition
Outdoor Side Condition
Dry Bulb Temp℃(℉)
Wet Bulb Temp℃(℉)
Dry Bulb Temp℃(℉)
Wet Bulb Temp℃(℉)
Rated Cooling
27(80.6)
19(66.2)
35(95)
24(75.2)
Rated Heating
20(68.0)
15(59.0)
7(44.6)
6(42.8)
Indoor Unit Working Temperature Range: 16°C(60.8 °F)~32°C(89.6 °F)
GMV DC Inverter VRF
4
3 Preparative for Installation
3.1 Pre-Installation Instruction
3.1.1 Checking Product Received
After receiving the product, please check if there is any damage caused by
transportation.Shipping damage is the responsibility of the carrier. Verify the model number,
specifications and accessories are correct prior to installation. The distributor or manufacturer
will not accept claims from dealers for transportation damage or installation of incorrectly
shipped units.
3.1.2 Before Installation
Carefully read all instructions for the installation prior to installing product. Make sure each
step or procedure is understood and any special considerations are taken into account before
starting installation. Assemble all tools, hardware and supplies needed to complete the
installation. Some items may need to be purchased locally. Make sure everything needed to
install the product is on hand before starting.
3.1.3 Codes & Regulations
This product is designed and manufactured to comply with national codes. It is installer‟s
responsibilities to install the product in accordance with such codes and/or any prevailing local
codes/regulations. The manufacturer assumes no responsibilities for equipment installed in
violation of any codes or regulations.
3.1.4 Replacement Parts
When reporting shortages or damages, or ordering repair parts, give the complete product
model and serial numbers as stamped on the product. Replacement parts for this product are
available through your contractor or local distributor.
3.2 Important Safety Instructions
Recognize Safety Symbols, Words, and Labels
The following symbols and labels are used throughout this manual to indicate immediate or
potential hazards. It is the owner‟s responsibility to read and comply with all safety information
and instructions accompanying these symbols. Failure to heed safety information increases the
risk of serious personal injury or death, property damage and/or product damage.
DANGER
: Immediate hazards which will result in property damage, product damage,
severe personal injury or death.
WARNING
: Hazards or unsafe pratices could result in property damage, product
damage, severe personal injury or death.
CAUTION
: Hazards or unsafe practices which may result in property damage,
product damage, severe personal injury or death.
Loading...