Gree ETAC207HP230VACP Installation Manual
Accessory Power Cord Assembly for
E-TAC II Packaged Terminal Air Conditioners
Models:
E2CORD-230V15A
E2CORD-230V20A
E2CORD-230V30A
POWER CONNECTION CHART
Unit Model
ETAC2-07HC230VA-A
ETAC2-09HC230VA-A
ETAC2-12HC230VA-A
ETAC2-15HC230VA-A
ETAC2-07HP230VA-A
ETAC2-09HP230VA-A
ETAC2-12HP230VA-A
ETAC2-15HP230VA-A
ETAC2-07HC265VA-A
ETAC2-09HC265VA-A
ETAC2-12HC265VA-A
ETAC2-15HC265VA-A
ETAC2-07HP265VA-A
ETAC2-09HP265VA-A
ETAC2-12HP265VA-A
ETAC2-15HP265VA-A
E2CORD-265V15A
E2CORD-265V20A
E2CORD-265V30A
Electric Heater - Amp (KW)
15A (2.5KW)
E2CORD230V15A
E2CORD265V15A
20A (3.5KW)
230/208 VOLTS
E2CORD230V20A
265 VOLTS
E2CORD265V20A
30A (5.0KW)
Not Available
E2CORD230V30A
Not Available
E2CORD230V30A
Not Available
E2CORD265V30A
Not Available
E2CORD265V30A
INSTALLATION INSTRUCTIONS
208/230v LCDI Power Cord (1)
*
*
265v Power Cord (1)
Wire Clamp (1)
Screw (1)
* Using 30A on these units could result in damage to your unit. * Only one power cord provided depending on kit ordered.
SAFETY PRECAUTIONS – Please read the following before installation.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
WARNING
CAUTION
NOTICE
WARNING
Failure to follow this warning could result in personal injury or death and/or unit operation and damage. Installing and servicing air conditioning equipment
can be hazardous due to system pressures and electrical components. Only trained and qualified personnel should install or service air conditioning
equipment. When working on air conditioning equipment, observe the precautions provided in literature, tags and labels attached to the unit.
1. Follow the National Electrical Code (NEC) or local codes and ordinances.
2. For personal safety, this unit MUST BE properly grounded.
3. Protective devices (fuses or circuit breakers) acceptable for unit installations are specified on the nameplate of each unit.
4. DO NOT use an extension cord with this unit.
This mark indicates procedures which, if improperly performed, might lead to the death or serious injury of the user.
This mark indicates procedures which, if improperly performed, might possibly result in personal harm
to the user, or damage to property.
Notice is used to highlight suggestions which will result in enhanced installation, reliability and operation.
– Electrical shock hazard and/or unit operation and damage hazard
INSTALLATION
Unit connecto
r
Junction box cover
Junction box
Unit connecto
Junction box cover
Junction box
Accessory
Power Supply Cord
Wire clamp
Wire clamp
WARNING
CAU TION
WARNING
–
WARNING
Disconnect, lockout and
tag all electrical power devices to unit including
disconnects, fuses and circuit breakers.
1. Remove front panel.
a. Pull out at the bottom to release it from the tabs (1).
b. Then lift up (2).
2
1
2. Remove junction box.
a. Remove junction box cover by removing three screws from front
(save these for later).
b. Remove junction box by taking out top, rear and side screws
(save these for later).
4. Re-install junction box and cover.
Secure power cord.
a. Re-install junction box using parts saved in Step 2.b.
b. Use wire clamp to secure power cord to basepan with
screw provided.
c. Replace junction box cover using parts saved in Step 2.a.
5. Replace front panel.
a. Place tabs over top rail (1).
b. Push Inward at bottom until panel snaps into place (2).
1
3. Connect power cord connector to unit connector.
6. Plug unit in and turn power on.
a. Units must be installed using the appropriate power cord kit.
See Power Connection Chart on page 1.
For complete instructions on these and other functions, as well
as important safety information, see the ETACII Owners Manual.
Accessory
Power Cord
For more information, visit GreeComfort.com.
66129920735
2
Cat. No: PTAC-CORD-1SI Specifications are subject to change without notice. Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice or without incurring obligations. ©2016. All rights reserved.
Loading...