GReddy AIR INTAKE SYSTEMS Nissan 370Z 2009-12 User Manual
Instruction Manual P/N: 12529003
Make: Nissan Model: 370z Year: 2009-2012 Engine: V6-3.7L
• Please read the entire instruction manual before proceeding.
• Ensure all components listed are present.
• If you are missing any of the components, call customer support at 949-588-8300.
• Ensure you have all necessary tools before proceeding.
• Do not attempt to work on your vehicle when the engine is hot.
• Disconnect the negative battery terminal before proceeding.
• Retain factory parts for future use.
Label Qty. Description Part Number
A 1 Air Filter (Pro DRY S) 61-90127
B 1 Tube #1 Passenger side 05-T3017P1
C 1 Tube #2 Driver’s side 05-T3017P2
D 2 Tube #3 05-T3017P3
E 2 Coupling: Elbow 2-3/4” ID x 45 Deg 05-01190
F 2 Coupling: Straight 2-3/4” ID x 1-3/4”L 05-01107
G 8 Clamp, 044 03-50019
H 2 Hose, 5/8” (2 inches) 05-00069
I 4 Screw, M4 x .7 x 8 03-50034
J 4 Screw, Hex Hd: M6 x 1 x 12 03-50032
K 1 Nut, Hex: M6 x 1 03-50059
L 5 Washer, Flat: 1/4” 03-50043
Installation will require the following tools:
Phillips screw driver, 10mm socket, Extention, Ratchet, Pliers & 5/16 nut driver.
Note: Legal in California for use on race vehicles only. The use of this device on vehicles used on public
streets or highways is strictly prohibited in California and others states that have adopted California
emission regulations.
Page 2
G
G
F
H
I
B
G
F
H
I
C
G
K
L
E
J
E
L
D
D
J
Page 3
A
L
GReddy.com
1
REMOVAL
2
1
Figure A
Refer to Figure A for step 1-2
Step 1: Begin removing the engine strut brace by removing the two nuts and one bolt from both the
passenger and driverside strut towers 1 .
Step 2: Remove the plastic cover located under the windshield wipers 2 and remove the two nuts
securing the strut brace to the vehicle, then remove the strut brace.
Page 4
REMOVAL
3
3
3
5
4
5
4
33
6
6
Figure B
Refer to Figure B for steps 3-6
Step 3: Remove the five mounting nuts from the engine cover and lift the cover out of the vehicle 3 .
Step 4: Disconnect the crank case ventilation from the intake tubes 4 .
Step 5: Disconnect both intake tubes from the throttle bodies by loosening the clamps 5 .
Step 6: Unplug the mass air flow sensor harnesses from the intake tubes and disconnect the plastic
retainer clips securing the wire harness to the air boxs 6 .
6
6
Page 5
GReddy.com
Loading...