Great Outdoors Pinnacle GP450, Pinnacle GP600 Assembly

PinnaclePinnacle

GP450/GP600 PINNACLE SERIES GRILLS

ASSEMBLY PROCEDURES

Tools Required: Knife or scissors; 7/16 (11 mm) wrench; 11/16” (17 mm) flat or adjustable wrench;

Phillips or #2 Robertson (square) screwdriver

Step 1: Unpack carton.

Box #1

Cut the strapping on the package, then lift off the carton cap. Remove the sleeve by lifting it straight

over the top of the Barbecue. Remove and unpack the enclosed parts boxes. Remove any protective cover­ing from stainless steel parts.

Box #4

Box #3

Box #2

(GP600)

Page 1

50001608 03/03 Rev.0 En

GP450/GP600 ASSEMBLY

Step 2: Install casters.

Required: (4) casters

Alternately prop up each end of the grill
with a block of wood or other solid item.
Position a caster stem into the plastic boss
in each corner of the bottom panel, and
push as far as possible by hand.

Caster

6 to 8”

Fig. 2

Step 3: Attach shelf supports.

Required: (2) left shelf supports; (2) right shelf supports; (8) 1/4–20 x 5/8” hex bolts; (8) 1/4” washers

(8) 1/4–20 x 5/8” Hex bolt (8) 1/4” Washer

Attach a left and a right shelf
support to the right side of the
grill base with (2) bolts and (2)
washers each. Tighten with a
7/16” (11 mm) wrench.

Repeat for left side.

Fig. 3

Page 2

Step 4: Attach front and side shelves.

Required: (2) side shelves; (1) left and (1) right front shelf; (2) shelf inserts

(6) #10–24 x 1/2” bolts; (6) #10–24 locknuts (see below)

(6) #10–24 x 1/2” Bolt

(6) #10–24 Locknut

Hook the left and right front shelves over the
corresponding front shelf supports, push towards
the grill base. Attach to the bottom of the control
console with (1) bolt and (1) nut each (Fig. 4a).

Assemble the side shelves to the shelf supports by
positioning them half way over the supports, then
sliding them towards the base, while pushing down
firmly on the front edge. The slots at the front edge
of the shelf should align with the tabs at the back of
the shelf supports (Fig. 4b).

GP450/GP600 ASSEMBLY

1

2

Fig. 4a

NOTE: On models with Side Burners, assemble the shelf with the open center
to the right-hand side of the grill. After completing this step, follow the
instructions in the Side Burner Kit.

Tap the shelf lightly to fully engage the slot and tab if necessary
(Fig 4c). Once aligned, fasten with a nut and bolt to the
underside of the supports (Fig. 4b).

Slot

Tab

(View rotated 90°)

Fig. 4c

Fig. 4b

Page 3