Great Lakes Case & Cabinet VCM5-FR, VCM5-FO Installation Instructions Manual
VCM5-FR, VCM5-FO
5" Vertical Cable Management & Accessories
Installation Instructions
1.866.TRY.GLCC (879-4522)
WeRackYourWorld.com
2
PREFACE
This manual is provided to prevent service personnel from committing an act
that results in the risk of re, electric shock, or injury to persons. Only trained
service personnel should receive, unpack, and assemble the Vertical Cable
Manager (VCM). In addition, only trained service personnel should manage
cables in the VCM.
SAFETY SYMBOLS USED IN THIS MANUAL
This manual provides general safety guidelines to be observed during
installation, operation, and maintenance of the VCMs.
WARNING:
Failure to follow directions in the warning could result in injury to persons or
loss of life.
Improper handling and use of the VCM could result in equipment damage,
serious injury, or possible death.
Only UL® Listed ITE (Information Technology Equipment) cable should be
managed with the VCM.
Be sure to read and follow all individual manufacturer equipment manuals for
safety and installation instructions.
Proper spacing is required when installing electrical equipment to avoid
electrical shock.
5" VERTICAL CABLE MANAGER
MOUNTING BRACKETS
There are two sets of 4 brackets that will allow you to mount the
cable management channels in multiple ways. Each bracket set
is compatible with different racks - ensure that the brackets that
are being used are the correct brackets for the rack. In addition,
bracket sets will allow VCMs to be mounted to the front or back
of rack uprights; however, some racks can only accept mounting
to the front of the upright.
PARTS LIST: VCM5-FO & VCM5-FR
COMPONENTS AND QUANTITIES ARE THE SAME FOR
VCM5-FO AND VCM5-FR, EXCEPT WHERE SPECIFIED
COMPONENT QTY.
VCM5-FO CHANNEL OR VCM5-FR CHANNEL 2
5" CHANNEL COVERS VCM5-FO: 2; VCM5-FR:4
BRACKET SET “A1” (BRACKETS ARE INSTALLED ON CHANNEL BY DEFAULT) 4
BRACKET SET “A2” 4
#12-24 SCREWS 8
#8-32 X 1/2" SCREWS 16
INSTRUCTION MANUAL 1
TOOLS REQUIRED: 3/8" NUT DRIVER, PHILLIPS HEAD SCREWDRIVER
3
BRACKET SET A1
COMPATIBILITY:
Bracket Set A1 is compatible with the following Great Lakes
racks:
GLRR-1984**(VCM can mount to the front or back side of upright)
4P1224-** (VCM can mount to the front or back side of upright)
4PM6-** (VCM must mount to front of upright)
4PHD29 (VCM must mount to front of upright)
MOUNTING BRACKET SET A1 MOUNTED TO THE FRONT
OF THE UPRIGHT
MOUNTING BRACKET SET A1 MOUNTED TO THE BACK
OF THE UPRIGHT
B
5.19
5.44
2
.
9
4
6
.
5
6
A
B
A
5.44
5.19
.
9
3
2
.9
4
A
Loading...