INSTALLATION INSTRUCTIONS
Correct string radius is achieved using three saddle heights.
Saddles are numbered (on the bottom of each saddle)
(lowest height),
be installed in the following order:
1
E
1. Insert string end in hole at base of string block cavity.
2. GENTLY tighten screw until it just touches the string.
3. Tighten with allen key an additional 1/4 TURN ONLY.
CAUTION: Excessive tightening is not required to keep string in
place. Overtightening screw may crack the housing and void your
warranty. Questions? Phone 604-940-5353, visit our website at
www.graphtech.com or e-mail sales@graphtech.com
2 (middle height) and 3 (highest), and should
2
B
(Saddle heights exaggerated slightly for illustration)
3
G
3
D
Insert string end here.
2
A
1
1
E
Loading...