Grant UVT-B-AR Operating Instructions Manual
UV-cabinet – DNA/RNA
UVT-B-AR
Operating instructions
For versions: V.3GB
V.3GD
Version 3.01 - May 2013
Page 2
Operating instructions
UVT-B-AR
Contents
1 Safety..........................................................................................4
2 General Information ..................................................................5
3 Getting Started...........................................................................6
4 Operation of UVT-B-AR.............................................................7
5 Specifications ............................................................................9
6 Guarantee and service ............................................................10
7 Declaration of Conformity.......................................................11
UVT-B-AR
Operating instructions
Version 3.01 - May 2013
Page 3
1. Safety
The following symbols mean:
Caution: Read these operating instructions fully before use and pay particular attention to
sections containing this symbols.
Caution: Do not work in the box or open the front protective screen while the open UV-lamp is
switched ON. Otherwise it can expose the operator to a dangerous level of UV light.
GENERAL SAFETY
Use only as specified in the operating instructions provided.
The unit should not be used if dropped or damaged.
After transport or storage allow the unit to dry out (2-3 hrs) before connecting to the mains.
Before using any cleaning or decontamination method except those recommended by the manufacturer,
check with the manufacturer that the proposed method will not damage the equipment.
Do not attempt to modify the unit.
ELECTRICAL SAFETY
Connect only to the mains with a voltage corresponding to that on the serial number label.
Ensure that the switches and plug are easily accessible during use.
Do not plug the unit into the main outlet without grounding, and do not use extension lead without
grounding.
Before moving the unit, disconnect the power plug from the mains outlet.
If liquid is spilled inside the unit, disconnect it from the mains and have it checked by a competent person.
DURING OPERATION
Do not operate the unit in environments with aggressive or explosive chemical mixtures.
Do not operate the unit if you think it may have been incorrectly installed or repaired.
For indoor use only.
Do not use outside laboratory rooms.
Do not work in the box while the open UV-lamp is switched ON.
BIOLOGICAL SAFETY
It is the user's responsibility to carry out appropriate decontamination if hazardous material is spilt on or
inside the equipment.
Version 3.01 - May 2013
Page 4
Operating instructions
UVT-B-AR
Loading...