Grandview 1GD-IRAnIII User Manual

GRANDVIEW REPRODUCING GENUINE COLORS

GRANDVIEW REPRODUCING GENUINE COLORS

Infrared Remote Controller Operation Instruction

Grandview Crystal Screen Canada Ltd.

#11- 3751 North Fraser Way,
Marine Way Business Centre,
Burnaby, BC, Canada V5J 5G4
Tel: [phone] Fax: [phone]
Website: www.grandviewscreen.ca

Guangzhou Grandview Crystal Screen Co., Ltd.

P.O. 511400 Federal Ind. Zone No. 363, Yushan West Road,
Shatuo, Panyu District, Guangzhou, Guangdong, China
Tel: [phone] Fax: [phone]
Website: www.grandviewscreen.com

ISO9001:2000
International Certification

Model：1GD-IRAnⅢ

Thank you for choosing the Grandview remote control.

Please read the instructions carefully before using. Keep instructions for future reference.

Contents

Contents

Diagnosis and treatment for malfunction

If the remote control can't work properly, please check it according to the following steps. While if you
can't find the same symptoms and right way to solve the problems please contact with Grandview's

1

local distributor or our ofter-sales team.

Safety Information

Working Principle

Installation Guide

Controller Instruction

Trouble Shooting

3-4

2

2

5

6

Symptom

The instruction LED

light on the receiver

doesn't work

The instruction light is

working but when you

press the button on remote

controller the light doesn't

twinkle.

Cause

1. Check power.

2. The improper cable connection.

3. Disconnected for fuse in receiver.

1. Batteries in remote controller run out or

wrong direction of fixing the cathode

and anode for batteries.

2. Incorrect cable connection of the receiver;

3. Inappropriate angle or distance of the

remote controller.

4. There is obstacles between emitter and

receiver.

5. The header don't plug with the receiver

tightly.

6. The receiver gets broken.

Measure

1. Make sure connect the power properly.

2. Connect the cable in right way ccording

to Wire circuit diagram.

3. Replace with new fuse.

1. Change the direction of batteries

according to the figure in set up for

controller batteries first,but if the

malfunction still exists then replace

them with new batteries.

2. Pls refer to cable diagram.

3. IR emitter only can work within 8 meters

and 30 degrees in front of the receiver.

4. Pls clean the obstacles between emitter

and header.

5. pls plug the header with the receiver tightly.

6. Contact with Grandview after-sales team

or contact with the local dealer.