Grandview 1GD-868MnIII User Manual

GRANDVIEW REPRODUCING GENUINE COLORS

GRANDVIEW REPRODUCING GENUINE COLORS

Radio Frequency Remote Controller Operation Instruction

Grandview Crystal Screen Canada Ltd.

#11- 3751 North Fraser Way,
Marine Way Business Centre,
Burnaby, BC, Canada V5J 5G4
Tel: [phone] Fax: [phone]
Website: www.grandviewscreen.ca

Guangzhou Grandview Crystal Screen Co., Ltd.

P.O. 511400 Federal Ind. Zone No. 363, Yushan West Road,
Shatuo, Panyu District, Guangzhou, Guangdong, China
Tel: [phone] Fax: [phone]
Website: www.grandviewscreen.com

ISO9001:2000
International Certification

Model：1GD-868MnⅢ

Thank you for choosing the Grandview remote control.

Please read the instructions carefully before using. Keep instructions for future reference.

Contents

Contents

Diagnosis and treatment for malfunction

If the remote control can't work properly, please check it according to the following steps. While if you
can't find the same symptoms and right way to solve the problems please contact with Grandview's

1

local distributor or our ofter-sales team.

Safety Information

Remote Control Functionality

Receiver Installation Guide

The Cable Circuitry of Receiver

Controller Instruction

Battery Replacing

Trouble Shooting

2

2

3

3

4

5

6

Symptom

The instruction LED

light on the receiver

doesn't work

The instruction light is

working but when you

press the button on remote

controller the light doesn't

twinkle.

Cause

1. Check power.

2. The improper cable connection.

3. Disconnected for fuse in receiver.

1. Batteries in remote controller run out or

wrong direction of fixing the cathode

and anode for batteries.

2. Incorrect programing connection.

3. Some parts of the receiver is damaged

if the manual control of receiver can

make the screen move up and down.

Measure

1. Make sure connect the power properly.

2. Connect the cable in right way ccording

to Wire circuit diagram.

3. Replace with new fuse.

1. Change the direction of batteries

according to the figure in set up for

controller batteries first,but if the

malfunction still exists then replace

them with new batteries.

2. Check the cable connection according

to Wire circuit for receiver.

3. Contact with your local distributor to

solve this problem.