6
Your heater connections have been checked at the
factory for leaks. Recheck all connections, as
movement in shipping can loosen.
Check for leaks even if your unit was assembled for
you by someone else.
Do not operate if gas leak is present. Gas leaks may
cause a fire or explosion.
You must follow all leak-checking procedures before
operating. To prevent fire or explosions when testing
for a leak:
1. Always perform leak test before lighting the
heater and each time the tank is connected for
use.
2. No smoking. Do not use or permit sources of
ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a
well-ventilated area.
4. Do not use matches, lighters, or any flame to
check for leaks.
5. Do not use heater until any and all leaks are
corrected.
If you are unable to stop a leak, disconnect the
LP gas supply. Call a gas appliance serviceman
or your local LP gas supplier.
Do not store or use gasoline or other flammable
liquids or vapors within 25 feet (7.62m) of this
appliance.
Do not use in an explosive atmosphere. Keep heater
area clear and free from combustible materials,
gasoline and other flammable vapors and liquids.
Keep all combustible items and surfaces away from
the heater at all times. Do not use this heater or any
gas product under any overhead or near any
unprotected combustible constructions.
Combustion of propane creates carbon monoxide,
which, when used in enclosed areas, can kill you.
It is essential to keep the heater’s valve compartment,
burners, and circulating air passages clean. Inspect
heater before each use.
Installation and repair should be done by a qualified
service person.
Do not alter heater in any manner.
Do not use the heater unless it is completely
assembled and all parts are securely fastened and
tightened.
This heater should be thoroughly inspected before
each use. Clean and inspect the hose before each use
of the appliance. If there is evidence of abrasion,
wear, cuts, or leaks, the hose must be replaced prior
to the appliance being put into operation.
Only for EU countries the regulator and hose are not
included in the grill package, should purchase it
from local store; but for AU they will be included in
the grill package.
Inspect heater before each use. If a damaged part is
detected, do not operate until an original equipment
part has been properly installed.
Use only Hauland Limited authorized parts. The use
of any part that is not factory authorized can be
dangerous. This will also void your warranty.
Top square lid and burner are extremely hot to touch
during operation. Never touch the lid or burner while
the heater is operating. Wait for unit to cool down
(approximately 45 minutes) after use.
During operation, do not touch burner assembly. The
surface of heater’s emitter can reach temperatures
approaching 870℃ (1600℉).
Do not install or use in or on boats or recreational
vehicles.
Do not use heater in winds that exceed 10M.P.H..
Unit will operate at reduced efficiency below
5℃(40℉)
Do not leave a lit heater unattended, especially keep
children and pets away from heater at all times.
Always use extreme caution when near heater. Alert
both children and adults to the hazards of high
temperatures to avoid burns or clothing catching fire.
Do not attempt to move heater when in use. Allow
the heater to cool before moving or storing.
Storage of heater indoor is permissible only if the
tank is disconnected, removed from the heater and
properly stored outdoors.
Do not attempt to disconnect the gas regulator from
the tank gas fitting while the heater is in use.
Always place your heater on a hard, level surface.
Use extreme caution on wooden decks.
Move gas hoses as far away as possible from hot
surfaces.
Keep all electrical cords away from a hot heater.
Do not use heater for indoor cooking or heating.
TOXIC fumes can accumulate and cause
asphyxiation.