GRAND EFFECTS 100-M Owner's Manual

GRAND EFFECTS

For your safety:

If you smell gas:

1. Shut off gas to the appliance

2. Extinguish any open flame
near unit.

3. If odor continues, immediately
call your gas supplier

For your safety:

Do not store or use any gasoline or
other flammable vapors and / or
liquids in the vicinity of this or any
other appliance.

(Manual Operation)

OWNER’S MANUAL

OPERATING AND MAINTENANCE INSTRUCTIONS

This manual should remain with the homeowner or parties responsible for operation.

(Rev C)

Fire Bowl

Model 100-M

2

Table of Contents

Gas Requirements Page 3
Installation Page 3
Operation Page 4
Maintenance Page 5

3

1.0 Gas Requirements:

1.1 Gas type: Natural / Propane

1.2 Gas Pressure: 7” wc 11”wc

1.4 Gas flow: 1 Burner System: 60,000-80,000 Btu/hr

Note: Check with your gas supplier to verify gas flows and pressures available at the location
of your installation. In many cases utility companies will install larger meters at no charge to
accommodate larger flows.

2.0 Installation

Warning: This unit is for outdoor use only

2.1 Do not install near any combustibles such as wood structures, fuels, clothing, fabrics
or dry vegetation.

2.2 Installation shall be performed by a licensed contractor. All aspects of installation
must conform to local codes, or in the absence of codes, with National Fuel Gas Code
ANZI Z223.1.

2.3 An approved gas valve or keyed valve shall be installed upstream of the unit and
located in an accessible area that is within 5ft from the Grand Effects Unit.

2.4 Maintain good piping practice by keeping pipe length and elbows to a minimum to
eliminate unnecessary pressure drops. (Do not use any flexible gas line)

2.5 Install the Grand Effects Unit as shown in Figures 1, 2 & 4. Figure 3 is an optional

configuration to catch dirty run-off water.

2.6 Install Mounting bracket as shown in Fig. 2. The Mounting Bracket should be secured
to the wall using three bolts.

2.7 Center Bowl on top of Mounting Bracket. The bowl should rest on top of the three
spacers located on Mounting Bracket. With hammer, carefully bend over metal prongs
to secure bowl.

2.8 Install 90 elbow and gas hose at gas connection as shown in Fig. 2. Connect gas hose
to Burner Assy.

2.9 With all gas connections tight, position Burner Assembly so that it sits level in the bowl.
Rotate as required so that the gas hose rests in a compact position.

Important: The Mounting Bracket must be installed for proper cooling and drainage.