Graco Children s PD170765, PD170766 Users manual

True Focus
Model 2V00
OWNER’S MANUAL
Keep Instructions For Future Reference
©2011 Graco PD148039C 4/11
Warnings to Parents and Other Users
Failure to follow these warnings and the assembly instructions could result in serious injury or death.
• STRANGULATION HAZARD. Keep the adapter
cords out of the reach of children. Do not use with extension cords.
• DO NOT place the Nursery Unit or its cord within your child’s reach. Do not put the Nursery Unit inside a crib or playard.
• Use ONLY with 110-120 volt AC electrical outlets.
Protect the AC adapter cords. Place them so they are not walked on or pinched by furniture or other items.
Allow for proper ventilation when units are in use. Do not cover the Nursery Unit or Parent Units with any object such as a blanket. Do not place it in a drawer or in any location which would mufe the sound or interfere with the normal ow of air.
• DO NOT immerse any part of the Nursery Unit or Parent Units in water. Clean only with a dry cloth.
2
• DO NOT place unit near water and moisture. Do not use the Nursery Unit outdoors. Do not use the Nursery Unit near possible wet areas, such as a bathtub, shower, wash basin, sink, laundry tub, swimming pool, wet basement, etc.
Keep Nursery Unit away from heat sources, such as replaces, radiators, stoves, and TVs or other appliances. Heat can damage the case or electrical parts.
• Do not use the Nursery Unit if :
• The adapter cords or plugs have been damaged.
• The unit has been exposed to liquids.
• Unit has been dropped or is damaged.
• DO NOT OPEN THE NURSERY UNIT, PARENT UNIT, OR ADAPTERS. No user-serviceable parts
inside. Risk of electrical shock, re or death.
• The antenna used for this nursery unit must be installed to provide a separation distance of at least 20 cm (7.9”) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
•While the parent unit may be portable, the antenna(s) used for this transmitter should not be co-located with any other antenna or transmitter.
FCC Statement :
WARNING Modications not authorized by the manufacturer may void users authority to operate this device.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
3
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
• Look for the FCC ID on the back of the Nursery Unit and inside the battery compartment on the Parent Unit.
4
Parts List
Parent Unit
(PD170841)
Adult assembly required.
Tool required : Phillips screwdriver
(1) Parent Unit
Battery
Nursery Unit
(PD170766)
(2) AC Adapter
5
Parent Unit
DC Adapter Jack
Belt Clip
Battery Compartment
Volume Up/Down
SoundLights
6
Zoom
In
Battery Status Indicator
Signal Strength Indicator
Navigation buttons
Menu
Power Zoom Out
Installing Batteries
1
The battery must be plugged into the Parent Unit before the unit will be ready for use. Use a Phillips head screwdriver to remove the battery door. NOTE : Screw should be loosened but stay attached to battery door.
2
Remove the battery pack from the packaging and plug into the back of the unit. Place the battery pack into the recess and press the wire into the slot on the side.
7
3
Replace the battery door and tighten the screw.
Using AC Adapters
4
The Parent Unit(s) uses a rechargeable battery pack
or standard 120 volt AC household current. To use AC adapters, plug the connector on the cord into the DC adapter jack on the side of the Parent Unit. Then plug adapter into a standard wall outlet.
Use ONLY the Graco adapters included with the
unit. Do not use these adapters with other equipment under any circumstances.
If units do not work, check that AC adapters are
plugged into working outlets.
8
Nursery Unit
Camera
Power
DC Adapter Jack
Battery Compartment
9
Battery Installation
5
Use a Phillips head screwdriver to remove the battery door. NOTE : Screw should be loosened but stay attached to battery door.
6
Insert 3-AA (1.5V-LR6) batteries. Make sure they are inserted correctly.
• Batteries will power the Nursery Unit in the event of a power outage. Only audio (no video) is operational when running on battery power.
• Batteries should be replaced periodically.
10
7
Using AC Adapters
Replace the battery door and tighten the screw.
8
• The Nursery Unit uses 3-AA (1.5V-LR6) batteries or standard 120 volt AC household current.
• To use AC adapters, plug the connector on the cord into the DC adapter jack on the back of the Nursery Unit. Then plug adapter into a standard wall outlet.
• Use ONLY the Graco adapters included with the unit. Do not use these adapters with other equipment under any circumstances.
• If units do not work, check that AC adapters are plugged into working outlets.
• When electricity is off (from a power failure, etc.), the Nursery Unit will operate on 3-AA (1.5V-LR6) batteries in audio mode only.
11
Loading...
+ 25 hidden pages