Graco Pack ‘n Play Playard with Quick Connect Portable Napper Deluxe Owner's Manual

Pack ‘n Play® Playard

Quick Connect™ Portable Napper Deluxe

©2016 PD349520B 12/16

Read all instructions BEFORE assembly and USE of product.

KEEP INSTRUCTIONS FOR FUTURE USE.

See back page for quick set up guide.

2

2-A Parts List

1 WARNING

2 Features

Pages 3-10

Pages 11

3-A Set Up
3-B Bassinet

4-A To Fold
4-B To Cover

3 Assembly Pages 12-18

4 Use

Pages 19-22

6-A Care & Maintenance
6-B Replacement Parts • Warranty Information
6-C Product Registration

6 Care Pages 40-46

5-A Parent Organizer
5-B Changing Table
5-C Portable Napper Deluxe

5 Accessories

Pages 23-39

3

Failure to follow these warnings and the

instructions could result in serious injury or death.

Setting Up the Playard

• THIS PRODUCT REQUIRES
ADULT ASSEMBLY.

• Keep fingers clear of top
corners during setup. Be sure
playard is completely set up
before use. Check that the four
top rails are completely latched,
the center of the floor is pushed
down, the mattress/pad is flat,
the straps are securely fastened
to the bottom of the unit and the
four corners are tucked under
the stiffeners. Always follow the
instructions in the owner’s
manual to set up the playard.

• Never use this product if there
are any loose or missing
fasteners, loose joints, broken
parts or torn mesh. Check
before assembly and
periodically during

use.

Using the playard

• The playard is for playing or
sleeping. When used for playing,
never leave child unattended and
always keep child in view. When
used for sleeping, you must still
provide the supervision
necessary for the continued
safety of your child.

• Always keep the playard away
from hazards in the area that
may injure your child.

• When child is able to pull to
standing position, remove large
toys and other objects that
could serve as steps for
climbing out.

• Stop using this product when
your child reaches 35 inches
(89 cm) in height, weighs more
than 30 lb (14 kg), or is able to
climb out.

• Do not modify playard or add
any attachments that are not
listed in the owner’s manual,
including an add-on bassinet.

• Child can become entrapped
and die when improvised
netting or covers are placed on
top of a playard. Never add
such items to confine child in
playard.

4

• NEVER leave child in product
with side lowered. Be sure side
is in raised and locked position
whenever child is in product.

• If refinishing, use a nontoxic
finish specified for children’s
products.

Avoiding Suffocation
Hazards

• Unlike cribs that have rigid

sides, the playard has flexible
sides. As a result, the playard
mattress/pad is specially
designed to prevent suffocation.
The playard mattress/pad has a
solid base, a certain length and
width, and is less than one inch
thick in order to meet safety
standards. Using a thicker or a
different sized mattress/pad may
allow a child’s head to get
between mattress/pad and the
side of the playard causing
suffocation.

• Infants can suffocate

• In gaps between a mattress
too small or too thick and
products sides

• On soft bedding.

NEVER add a mattress, pillow,
comforter or padding. Use ONLY
mattress pad provided by Graco.
Mattress dimension: 27”x 36”
(68.5 cm x 91.4 cm).

• To reduce the risk of SIDS,
pediatricians recommend
healthy infants be placed on
their backs to sleep, unless
otherwise advised
by your physician.

• Never use plastic shipping
bags or other plastic film as
mattress covers not sold and
intended for that purpose. They
can cause suffocation.

• NEVER use a water mattress
with the playard.

• If a sheet is used with the pad,
use only the one provided by
Graco for Quick Connect
Playards or one specifically
designed to fit the dimensions
of the mattress/pad.

Avoiding Strangulation
Hazards

• Strings and cords can cause
strangulation. Keep strings and
cords away from child.

• NEVER place the playard
near a window where
cords from blinds or
drapes can strangle a child.

• NEVER hang strings on or
over the playard.

• NEVER place items with a
string around a child’s
neck, such as hood strings,
pacifier cords, etc.

• NEVER attach strings to
toys.

This product is not intended
for commercial use.

5

FOR SAFE BATTERY USE:

Keep the batteries out of children’s reach.
Any battery may leak battery acid if mixed with a different battery type,

if inserted incorrectly (put in backwards) or if all batteries are not
replaced or recharged at the same time. Do not mix old and new
batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-metal hydride, nickel-cadmium) batteries.

Any battery may leak battery acid or explode if disposed of in fire or an
attempt is made to charge a battery not intended to be recharged.
Never recharge a cell of one type in a recharger made for a cell of
another type.

Discard leaky batteries immediately. Leaky batteries can cause skin
burns or other personal injury. When discarding batteries, be sure to
dispose of them in the proper manner, according to your state and
local regulations.

Remove batteries before storing product for a prolonged period of time.
Batteries left in the unit may leak and cause damage.

Recommended type batteries—alkaline disposables, 1-D (LR20-1.5V)
(not included). NEVER mix battery types. Change batteries when
product ceases to operate satisfactorily.

6

Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.

This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device,pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that
to which the receiver is needed.

• Consult the dealer or an experienced radio/TV technician for help.

11

2-A Parts list

This model may not include some

features shown below. Check

that you have all the parts for this

model BEFORE assembling your

product. If any parts are missing,

call Customer Service.

Tools required:

Flathead Screwdriver

ALL MODELS

A B C D

E

F

2X

H I J

K

L

2X

G

12

3-A Set Up

SNAP!

1. Disconnect straps holding
mattress around playard.

2. Remove mattress from around
playard.

3. Pull up on side rails in middle
above push button until all
four sides are locked. DO NOT
push center down yet.

13

SNAP!

4. When setting up, lock rails

BEFORE lowering center.

Be sure top rails have become
rigid. If not, pull up again until
they are rigid. If top rails do
not latch, lift the center of the
floor higher.

5. Hold one end of the unit up and
push the center of the

floor

down.

6. Insert the mattress/pad soft
side up into the playard.
Always use mattress/pad soft
side up.

14

7. Put two tabs under mattress/
pad through button holes and
fasten securely on bottom of
unit.

8. Pull strap through bottom of
playard and wrap around tube
and refasten snap. Repeat on
other corners.

9. Tuck four corners of mattress/
pad under corner stiffeners.

SNAP!

15

3-B Bassinet

WARNING

SUFFOCATION HAZARD Infants have suffocated:

• In gaps between extra padding and side of the bassinet, and

• On soft bedding.
Use ONLY mattress/pad provided by Graco. NEVER add a pillow,

comforter or another mattress for padding.

• FALL HAZARD: To help prevent falls, do not use this product when
the infant begins to push up on hands and knees or weighs over
15 lbs (6.8 kg), whichever comes first.

• Use bassinet with only one child at a time.

• Never place a child under the bassinet.

• The bassinet must be fully assembled and installed, including four
metal tubes, four corner mounts, two clips and mattress/pad, before
using. Do not modify bassinet or add any attachments that are not
listed in the owner’s manual.

• DO NOT store the bassinet in the playard while in use.

• To help prevent heat build-up inside the playard and to avoid
overheating your child, when using the bassinet DO NOT use an
outdoor canopy.

• To reduce the risk of SIDS, pediatricians recommend healthy
infants be placed on their backs to sleep, unless otherwise advised
by your physician.

• If a sheet is used with the pad use only the one provided by Graco
or one specifically designed to fit the dimensions of the bassinet.

• Never place child in bassinet while accessories are attached.

17

1. Release snap straps and hook

and loop straps on bottom of
playard. Pull mattress fully out
of playard.

2. Attach 4 bassinet mounts in the

four corners and 2 clips over
buttons on the long sides.