Failure to follow these warnings and the
instructions could result in serious injury or death.
2
Setting Up the Pack ’N Play
• THIS PRODUCT REQUIRES ADULT ASSEMBLY.
• Keep fingers clear of top corners during setup. Be sure Pack ’N Play
is completely set up before use. Check that the four top rails are
completely latched, the center of the floor is pushed down, and the
mattress is flat and secured by the VELCRO
®
straps. Always follow the
instructions in the owner’s manual to set up the Pack ’N Play.
• Before each use, inspect this product for damaged hardware,
loose joints, missing parts or sharp edges. Do not use Pack ’N Play
if any parts are missing or broken. Call USA 1-800-345-4109
(Canada 1-800-667-8184) for replacement parts or owner’s
manual. Do not substitute parts.
Using the Pack ’N Play
• The Pack ’N Play is for playing or sleeping. When used for playing,
never leave child unattended and always keep child in view. When
used for sleeping, you must still provide the supervision necessary for
the continued safety of your child.
• Always keep the Pack ’N Play away from hazards in the area that may
injure your child.
• When child is able to pull to standing position, remove bumper pads,
large toys, and other objects that could serve as steps for climbing
out.
• Stop using this product when your child reaches 35 inches (89 cm) in
height, weighs more than 30 pounds (14 kg), or is able to climb out.
• Do not modify Pack ’N Play or add any attachments that are not
listed in the owner’s manual, including an add-on bassinet.
• DO NOT leave child in product with side lowered. Be sure side is in
raised and locked position whenever child is in product.
• If refinishing, use a nontoxic finish specified for children’s products.