Graco Ready2Grow, Click Connect Owner's Manual

/WNERS-ANUAL

2EADY'ROW

™

#LICK#ONNECT

™

Graco PD232784A 3/13

Failure to follow these warnings and the

assembly instructions could result in serious injury or death.

sPLEASE SAVE OWNER’S

MANUAL FOR FUTURE USE.

sADULT ASSEMBLY REQUIRED.
sNEVER LEAVE child

unattended. Always keep child
in view while in stroller.

sAVOID SERIOUS INJURY from

falling or sliding out. Always use
seat belt. After fastening buckles,
adjust belts to get a snug fit
around your child.

sAVOID FINGER ENTRAPMENT:

Use care when folding and
unfolding the stroller. Be certain
the stroller is fully erected and
latched before allowing your
child near the stroller.

sAVOID STRANGULATION.

DO NOT place items with a
string around your child’s
neck, suspend strings from
this product, or attach strings
to toys.

s NEVER USE STROLLER ON

STAIRS or escalators. You may

suddenly lose control of the
stroller or your child may fall out.
Also, use extra care when going
up or down a step or curb.

sSTROLLER TO BE USED only

at walking speed. Product not
intended for use while jogging,
skating, etc.

sUSE OF THE front seat, bench

seat or standing platform with
a child weighing more than 50
lbs (22.7 kg) or taller than 45 in.
(114.3 cm) will cause excessive
wear and stress on the stroller.

sUSE OF THE elevated rear seat

with a child weighing more than
40 lbs (18.1 kg) or taller than 43
in. (109.2 cm) will cause excesive
wear and stress on the stroller.

sTIPPING HAZARD! DO NOT

OVERLOAD BENCH SEAT,
ELEVATED SEAT, FRONT SEAT
OR STANDING PLATFORM
PAST THE MANUFACTURERS
RECOMMENDED WEIGHT
RATING.

sTO PREVENT TIPPING, do not

place more than 3 lbs (1.4 kg)
on the parent’s tray.

s TO AVOID BURNS, never put

hot liquids in the parent’s tray.

sTO PREVENT A HAZARDOUS,

UNSTABLE CONDITION, never

place purses, shopping bags,
parcels or accessory items on the
handle or canopy.

sTO PREVENT A HAZARDOUS,

UNSTABLE CONDITION, do not

place more than 10 lbs
(4.5 kg) in the storage basket
and more then 2 lbs (0.9 kg) in
the canopy pockets (on certain
models).

sDO NOT use storage basket as a

child carrier.

sNEVER ALLOW YOUR

STROLLER to be used as a toy.

sDISCONTINUE USING YOUR

STROLLER should it become

damaged or broken.

USING GRACO® INFANT CAR
SEAT WITH STROLLER:

sUSE ONLY A GRACO®

SNUGRIDE

®

CLICK CONNECT™

CAR SEAT with this travel

system. (Not intended for use
with SnugRide®, SnugRide® 30,
SnugRide® 32, SnugRide® 35,
Infant Safeseat™, AUTOBABY,
LOGICO S, JUNIORBABY and
ASSURA infant car seats.)
Improper use of this stroller with
other manufacturers’ car seats
may result in serious injury or
death.

sREAD THE MANUAL provided

with your Graco car seat before
using it with your stroller.

sFront tray MUST be installed in

the front location to be used for
the car seat.

sALWAYS SECURE your child

with the car seat harness when
using the car seat in the stroller.
If your child is already in the
car seat, check that the child is
secured with the harness.

TO PUT CHILDREN IN THE
STROLLER:

sYou may use this stroller with

two infant car seats. Refer to the
section “To Attach Graco® Infant
Car Seat” pages 36-43. Only
use a GRACO® SNUGRIDE

®

CLICK CONNECT™ CAR SEAT

only.

0ARTSLIST

Check that you have all the parts for this model BEFORE

assembling

your product. If any parts are missing, call Customer Service.

No tools required.

!LLMODELS

/NCERTAINMODELS

2X

2X

2X2X 2X 2X

2X 2X2X

2X

To Open Stroller 

1

2

CHECK that the stroller is

completely latched open every
time you open the stroller and
before continuing with the rest
of the assembly steps.

3

SNAP!

2

0ARENTS4RAY

1

2X

Attach tray by sliding onto mounts
as shown.

Secure tray to the stroller with
the 2 screws provided.

Rotate tray down until it snaps
into place.

Never use stroller without the
parent tray completely latched
into place.

SNAP!

SNAP!

3

2EAR!XLE

WARNING Choking

Hazard: Remove and
immediately discard foam on
the rear axle.

1

2

SNAP!

BEFORE attaching wheel: Be sure to place stroller on top of a piece of
card board or some other protective cover to prevent any damage to
floor.

Insert brake assembly onto rear
legs. Brake pedal must point
towards the rear of stroller.

Lift the standing platform up
and make sure the 3 hooks
latch onto the crossbrace as
shown.

Slide the sides of the standing
platform onto the frame legs as
shown.

Hooks

1

2

3

3TANDING0LATFORM

Check that the tabs on both
sides of the standing platform
are snapped in place.

4

SNAP!

2EAR7HEELS

Firmly attach hub adapter onto
wheel.

1

2

3

Place wheel on axle.

Place washer on axle.

Push straight side of pin through axle
hole. Pin will separate around the axle.
Curved end of pin MUST face up as
shown.

4

5

SNAP!

Snap hubcap over pin as shown.

Repeat steps 1-5 (Rear Wheels )
on other side.

&OOTREST

1

2

Attach footrest as shown.

Make sure to slide the peg
into the channel of the
footrest.

3

Insert the tab over the
footrest pin as shown.

Check that wheels are
securely attached by pulling
on wheel assemblies.

SNAP!

2X

1

2

&RONT7HEELS 

Canopy

1

Insert small canopy into the
canopy mounts on each
side of the stroller

, with the
padded edge facing towards
the front as shown.

Insert large canopy into the
canopy mounts on each side of
the stroller

, with the padded edge

facing towards the rear as shown.

Small canopy

Large canopy

2

To adjust.

3

#HILDS4RAY

WARNING Always secure your child with the seat belt. The tray

is not a restraint device. DO NOT lift the stroller by the child’s tray.
Use

care when snapping the tray on the stroller with a child in the

stroller.

SNAP!

To open the tray.

1

2

%LEVATED2EAR3EAT

Make sure seat is snapped
securely onto pegs on each
side of the frame.

Attach seat as shown.

1

2

SNAP!

WARNING Do not allow child to stand on seat.

Never use seat in vehicle or in any other product.

4

You must first attach
the hook on the flap to
the stroller frame before
fastening the snap.

Fasten the snap button to
the stroller frame as shown.
Repeat on other side.

3

5

6

Insert the crotch strap buckle
into the underside of the
parent tray.

SNAP!

To release crotch strap, press
button as shown.
To remove elevated seat,
reverse steps.

To access basket, push
tabs toward the middle of
seat and rotate forward as
shown.

Do not allow child to stand on seat.

Never use seat in motor vehicle or

on any other product.

"ENCH3EAT

1

To close: Push seat up and
snap the side tabs into
place as shown.

SNAP!

2

4O3ECURE#HILD

2

Use slide adjuster at shoulder and waist
for tighter adjustment. To change
shoulder harness slots.

4

1

3

0OINT(ARNESS

0OINT"UCKLE

1

2

3

4

To convert to 3-pt harness.

Use slide adjuster at waist for
tighter adjustment. When
using bench seat, follow
steps 3-5 on this page.

5

To Change Shoulder Harness Slots

Remove harness covers as shown.

1

2

Slide adjuster

Remove both shoulder harness straps as
shown.

5

Remove head support as shown.

3

4

4O2ECLINE&RONT3EAT

1

Recline tab

Recline strap

WARNING When making

adjustments to the stroller seat, make

sure child’s head, arms, and legs are clear of moving seat parts and
stroller frame.

2

3

To recline, pull recline tab

down.

T

o raise, pull recline strap

up.

Head Support (on certain models)

Only use this head support
on this stroller. Never use
this head support on any
other product.

"RAKE

WARNING

CHECK that brake

is on by trying to
push stroller.

1

2

3WIVEL7HEELS

1

2

Front swivel wheels lock for
use on uneven surfaces such
as grass, stones or gravel.

4O&OLD3TROLLER 

3

Before folding stroller:(1) remove infant carrier if in use; (2) adjust
seat back to upright position; (3) lock brake.
(4) fold canopies

1

2

1

2

3

4

WARNING Do not allow child to stand on seat.

Never use seat in vehicle or in any other product.

To Attach Graco®

Infant Car Seat on Elevated Rear Seat

Pull flap over the seat pad as
shown.

1

Check to make sure the flaps
are installed before beginning
to attach infant carseat to the
elevated rear seat.

Flaps

3

2

Remove both shoulder harness
straps and the waist straps as
shown.

Remove head support
and harness covers.

5

4

Insert carseat into stroller and push
down on car seat until the latches
snap into the Click Connect™
mounts.

Check that infant car seat is
securely attached by pulling
up on it.

Push seat pad down into the seat
to expose the Click Connect™
mounts on either side of the
seating area.

Mounts

6

7

sTo remove car seat: squeeze

release handle at back of car
seat, and lift car seat out of
the stroller.

To

Attach Graco® Infant Car Seat to Front Seat

1

Remove small canopy.

2

Recline the stroller seat back to its

lowest position and insert carseat

into stroller and push down on car

seat until the latches snap into the

Click Connect™ mounts.

Open flaps inside
seating area to expose
Click Connect™
mounts.

3

4

5

SNAP!

sTo remove car seat: squeeze

release handle at back of car
seat, and lift car seat out of
the stroller.

Check that infant car seat is
securely attached by pulling
up on it.

READY2GROW™ CLICK

CONNECT™ Use

Positions

WARNING DO NOT allow child to stand on platform, facing

backwards. To avoid falling, child must hold onto stroller frame.

Care and Maintenance

sDO NOT MACHINE WASH SEAT. It should only be wiped with a

mild soap, taking care not to soak the material. NO BLEACH.

sREMOVABLE SEAT PAD (if so equipped) refer to your care tag on

your seat pad for washing instructions. NO BLEACH.

sTO CLEAN STROLLER FRAME, use only household soap and warm

water. NO BLEACH or detergent.

sFROM TIME TO TIME CHECK YOUR STROLLER for loose screws,

worn parts, torn material or stitching. Replace or repair the parts as
needed. Use only Graco replacement parts.

sEXCESSIVE EXPOSURE TO SUN OR HEAT could cause fading or

warping of parts.

sIF STROLLER BECOMES WET, open canopy and allow to dry

thoroughly before storing.

sIF WHEEL SQUEAKS, use a light oil (e.g., WD-40, 3-in-1,

or sewing machine oil). It is important to get the oil into
the axle and wheel assembly as illustrated.

sWHEN USING YOUR STROLLER AT THE BEACH

completely clean your stroller afterward to remove sand and salt from
mechanisms and wheel assemblies.