234
© 1999 Graco 363-7-99
Congratulations on your purchase of a
Graco
®
Pack N Play®!
Graco is the recognized leader in the
design and manufacture of quality baby
products. We believe your new Graco
®
Pack N Play®is a wise choice, promising
many hours of enjoyment for your baby.
Customer Satisfaction
Our goal is to make every product the best it
can be! We are also committed to supporting our
products after purchase. If you would like to speak
to Graco about your product, please contact our
Customer Service Department at 1-800-345-4109
or visit our Internet website, www.gracobaby.com.
Our knowledgeable staff will be ready to answer
any questions you may have concerning parts, use
or maintenance. When you call, please have the
model and serial numbers ready so your call
may be processed quickly and efficiently.
OWNERS
MANUAL
Model Nos. 9120, 9122, 9125,
9126, 9130, 9131, 9132 & 9135
Pack N Play
®
Read all instructions BEFORE
assembly and use of this product.
Keep instructions for future use.
We recommend that you keep these instructions
with your Pack N Play. A storage pocket has been
provided for them on the bottom panel of your unit.
Failure to follow these warnings and the assembly
instructions could result in serious injury or death.
Setting Up the Pack N Play
!
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
!
Keep fingers clear of top corners during setup.
Be sure Pack N Play is completely set up before use.
Check that the four top rails are completely latched, the
center of the floor is pushed down, and the mattress is
flat and secured by the
VELCRO
®
straps. Always follow
the instructions in the owners manual to set up the
Pack N Play.
!
Before each use, inspect this product for damaged
hardware, loose joints, missing parts or sharp edges.
Do not use Pack N Play if any parts are missing
or broken.
Call 1-800-345-4109 for replacement parts or owners
manual. Do not substitute parts.
Using the Pack N Play
!
The Pack N Play can be used as a playard or a
sleeping crib. When used as a playard, never leave
child unattended and always keep child in view.
When used as a sleeping crib, you must still provide
the supervision necessary for the continued safety of
your child.
!
Always keep the Pack N Play away from hazards in the
area that may injure your child.
!
Do not add padding or other objects inside the Pack N
Play that will permit your child to climb out.
!
Stop using this product when your child reaches
35 inches (89 cm) in height, weighs more than 30
pounds (14 kg), or is able to climb out.
!
Do not modify Pack N Play or add any attachments
that are not listed in the owners manual, including an
add-on bassinet.
Avoiding Suffocation Hazards
!
Unlike cribs that have rigid sides, the Pack N Play has
flexible sides. As a result, the Pack N Play mattress is
specially designed to prevent suffocation.
The Pack N Play mattress has a solid base, a certain
Failure to follow these warnings and
instructions could result in serious injury or death.
Your Pack N Play®may be used as a playard or portable crib. Read and follow the warnings and
instructions in this manual and those found on the bottom of the Pack N Play. The short time you
spend reading the instructions and warnings will help you use your Pack N Play properly.
Model No. _________
Serial No. _________
Dear Customer,
Please fill in the model and serial numbers
above from the label on the center of the
bottom of your new Pack N Play.
To Set Up Your Pack N Play
®
Step 1.
Undo the three VELCRO
®
straps. Fold
VELCRO
®
straps
back onto themselves.
Set mattress aside.
Step 2.
IMPORTANT: Leave
center of floor UP
until all four top
rails are latched.
Grasp the bottom of two
of the top rails, and pull
up until you hear a click.
Be sure top rails
have become rigid.
If not, pull up again
until they are rigid.
FOR SMOOTH SETUP and takedown, its
important to remember one thing: the center
of the floor must be at least halfway up when
locking OR unlocking rails (see picture below).
Therefore:
!!
When setting up, lock rails
BEFORE lowering center.
!!
When taking down, raise center halfway
BEFORE unlocking rails.
Step 3.
Pull up the other two sides
until they latch.
If top rails do not latch,
lift the center of the floor
higher. Center of floor
must be at least halfway
up for the latches to catch
properly.
Be sure all top rails are
rigid.
Step 4.
Hold one end of the
unit up and push the
center of the floor down.
Setting up the Pack N Play®is easy,
once you know how:
length and width, and is less than one inch thick in order
to meet safety standards. Using a thicker or a different
sized mattress may allow a childs head to get between
mattress and the side of the Pack N Play causing
suffocation.
!
To help prevent suffocation from entrapment,
USE ONLY THE MATTRESS PROVIDED BY GRACO.
Never use additional mattress or padding.
!
Never use plastic shipping bags or other plastic film as
mattress covers not sold and intended for that purpose.
They can cause suffocation.
!
Do not use a water mattress with the Pack N Play.
Avoiding Strangulation Hazards
!
Strings and cords can cause strangulation. Keep strings
and cords away from child.
!
Do not place the Pack N Play near a window where
cords from blinds or drapes can strangle a child.
!
Do not hang strings on or over the Pack N Play.
!
Do not place items with a string around a childs neck,
such as hood strings, pacifier cords, etc.
!
Do not attach strings to toys.
This product is not intended for commercial use.
CARE AND MAINTENANCE
FROM TIME TO TIME CHECK YOUR PACK N PLAY
for worn parts, torn material or stitching. Replace
or repair the parts as needed. Use only Graco
®
replacement parts.
IF PACK N PLAY IS USED AT THE BEACH, you
MUST clean sand off your Pack N Play, including the
feet, before packing it into cover. Sand in top rail lock
may damage it.
TO CLEAN PACK N PLAY, use only household soap
or detergent and warm water. NO BLEACH.
TO WASH CARRY BAG, machine wash in lukewarm
water on delicate cycle and drip-dry. NO BLEACH.
Top rail
5
363-7-99
6 87
Toy Bag
(on certain models)
Toy bag snaps on end of
unit. Maximum weight 2 lbs
(0.9 kg).
DO NOT machine wash or dry
in a dryer. DO NOT dry clean.
Spot clean with a damp cloth
and a mild detergent. NO
BLEACH.
At first your Pack N Play may
be like a new pair of shoes.
You may need to break it in by
slightly stretching the netting
and fabric. If the center does not
stay down, place some weight
(several books) in the center of
the unit and let it stand
overnight.
Step 5.
Place the mattress into your
unit with padded side up.
Always use your unit with
mattress installed soft side up.
Slide the two
VELCRO
®
straps
through slots in bottom of Pack
N Play and fasten to VELCRO
®
on underside. This will prevent
mattress from moving.
Your Pack N Play is ready to
use.
Side Flap
(on certain models)
You can raise side flap if
desired.
Unfasten
VELCRO
®
straps at
bottom of flap. Roll flap up.
Fasten in place with snap loops
at top.
To Use Your Changing Table
(on certain models)
Parts List
CHECK that you have all parts listed below
BEFORE assembling your changing table.
No tools required.
Long tube (2)
Short tube (2)
Changing pad
Accessory bag
Changing
table
To protect your child from falls and other injuries:
Always stay within arms reach of your child when
using the changing table. Always use waist belt when
child is on the changing table. Never leave child
unattended.
The changing table is designed for use only with this
Graco Pack N Play. Do not attempt to use it with any
other product. Before each use, make sure the
changing table is properly secured to the Pack N Play
by pushing down firmly in the middle of the changing
table. The changing table should not fall.
Do not use the changing table as a sleeping or play
area.
Weight limit for the changing table is 25 pounds
(11 kg). Do not use the changing table as extra
storage. Always remove the changing table when
your child is in the Pack N Play.
The Pack N Play changing table can be used on the
floor without being attached to the Pack N Play.
Never place the changing table on a piece of furniture,
bed, counter or any raised surface from which the
changing table or your child could fall.
Step 1.
Lay changing table flat on floor with short side in front
of you and belt facing up. Gently slide one long tube into
opening on long side exactly as shown.
Repeat on other long side.
Step 2.
Slide one short tube
into opening on end
as shown.
Be sure folding side of
hinge faces pad as
shown.
DO NOT insert other
short tube at this time.
Fold side
of hinge
Long
side
Short side
Step 3.
Turn up long tube so
that its end points down.
Insert end of long tube
into opening on end of
short tube as shown.
DO NOT slide short
tube up around the bend
of long tube until you
have finished next step.
Make sure fabric does not get caught in opening when
inserting long tube into short tube.
Step 4.
Repeat step 3 on other
end of short tube, then
slide short tube ends
up onto long tubes.
TO AVOID TEARING
FABRIC, slide the
short end up before
proceeding with
step 5.
Step 5.
Now repeat steps
2, 3 and 4 on how to
install the short tube
on the other end of
the changing table.
If the short tubes
have been inserted
correctly, the
changing table should
be able to FOLD UP in
the center as shown.
If you cannot fold the
tubes up in the center,
review steps 2, 3, and 4.
Step 6.
Place pad in changing
table with vinyl side up.
Pull belt straps through
holes in center of pad.
Step 7.
Insert VELCRO®straps
into the four slots at
the corners of changing
table and attach to
VELCRO
®
on underside
of changing table. This
will prevent pad from
moving.
Step 8.
Place changing table on
Pack N Play as shown.
Make sure tubes are
placed securely over
the sides of the
Pack N Play
®
.
Check that the
changing table is
properly supported by the
Pack N Play
®
by pushing
firmly down into center of
changing table.
Short tube side
Slide ends up
Fold up
9
363-7-99
10 11
To Fold Changing Table
Step 1.
Pull up on waist belt
straps to fold.
Step 2.
Ends of long tubes
must point up when
folded as shown.
Step 3.
To carry or store your changing table with your folded
Pack N Play, see To Cover Your Pack N Play section
in these instructions.
!
If top rails do not unlatch, lift
!
the center of the floor higher.
!
Both tubes must be released
!
for the top rail to fold.
Step 1.
Release the two VELCRO®straps
under the Pack N Play, and
remove the mattress.
To Fold Your Pack N Play
®
To fold the top rail:
!
Lift up slightly on the top rail.
!
Push up on the button located under the symbol
!
to release the two tubes.
!
Push down.
Push UP button
under fabric
Step 4.
Pull center up all the way.
To Use Accessory Bag
(on certain models)
Snap accessory bag
onto end of Pack N Play
with four snaps as shown.
Step 2.
IMPORTANT: Raise center
halfway BEFORE unlocking
rails.
Grasp center loop as shown
and pull up approximately
halfway to the top rails.
Step 3.
The top rail has a center piece
with two tubes hidden under the
fabric. The button on the bottom
of the center piece releases the
two tubes when it is pushed up.
Center
piece
Tube
Replacement Parts
Instructions for ordering Pack N Play®parts:
Complete form below. Your Pack N Play model number
MUST be included on the form to ensure proper
replacement parts. Your model number can be found
on a label on the center of the bottom of the unit.
Payment must accompany your order.
Return the form below with payment to:
GRACO CHILDRENS PRODUCTS INC.
CUSTOMER SERVICE DEPARTMENT
P.O. BOX 100, MAIN STREET
ELVERSON, PA 19520
IF YOU NEED HELP
If you have any questions or if you need
any part not listed, please call toll-free:
1-800-345-4109
or visit our Internet website, www.gracobaby.com.
Model Number
(Must be filled in)
SHIP TO:
Name
Address
City, State, Zip
( )
Telephone
Check enclosed
(payable to Graco Childrens
Products Inc.)
Charge to credit card:
Visa
MasterCard
Discover
Account #:
Expiration date:
Signature:
Mattress
Carry bag
Long tube
Short tube
Changing pad
Changing table
Accessory bag
Toy bag
Fitted sheet
Parts List:
Mattress .....................
Carry bag ...................
Changing table parts:
Long tube* ..................
Short tube* .................
Changing pad* ...........
Changing table* .........
Accessory bag* ..........
Toy bag* ......................
Fitted sheet....................
* On certain models
Price:**
$19.00
$13.00
$ 9.00
$ 7.00
$10.00
$15.00
$ 7.00
$13.00
$10.00
** Prices subject to change without notice.
To Cover Your Pack N Play
®
On changing table models, turn unit
upside down so that feet point up.
Pull the cover over your unit. Turn
unit over.
Before pulling bag up, insert folded
changing table into the side opposite the handle as shown. Pull bag
up to cover end. Zip together.
Step 1.
Pull cover over your unit. Be sure
the carrying handle attached to the
Pack N Play mattress is exposed.
Certain models have a second
handle on the carrying bag.
Step 2.
Zip together.
Total:
Shipping
& handling: $5.00
6% sales tax
(PA only):
Total amount
due:
Step 6.
Find the bottom corner belt loop
(only one). This loop is for holding
unit and mattress together while
carrying.
Step 7.
Wrap the mattress around your
unit. Fasten together the VELCRO
®
straps, attaching the bottom strap
to the bottom corner belt loop.
Step 5.
Gather your unit together.
Do not force.
If unit will not fold, look for
a partially latched top rail.
Squeeze the latch button to
release the rail.
12
Loading...