Page 1
234
© 1999 Graco 751-6-99
Failure to follow these warnings and the assembly instructions
Congratulations on your purchase of a
Graco
®
stroller!
Graco is a world leader in strollers and
has helped thousands of parents transport
their children in comfort. We believe your
new Graco
®
stroller is a wise choice,
promising many hours of enjoyment for
your baby.
Before using your stroller, please take a
few minutes to read this Owners Manual.
The short time you spend reading these
instructions will help you assemble and
use your stroller properly.
Please save your Owners Manual
for future use.
Customer Satisfaction
Our goal is to make every product the best it
can be! We are also committed to supporting our
products after purchase. If you would like to speak
to Graco about your product, please contact our
Customer Service Department at 1-800-345-4109
or visit our Internet website, www.gracobaby.com.
Our knowledgeable staff will be ready to answer
any questions you may have concerning parts, use
or maintenance. When you call, please have the
model and serial numbers ready so your call
may be processed quickly and efficiently.
OWNERS MANUAL
Stroller
Avoid serious injury from falling or
sliding out. Always use seat belt.
Never leave child unattended.
Always keep your child in view.
DO NOT place purses, shopping
bags, parcels and accessory items
on handle or canopy. They may fall
on the child or change the balance
of the stroller and make it unstable.
Child may slip into leg openings and
strangle. Never use in a reclined carriage
position unless front footrest is raised to
cover the front opening and wire snapped
into lower notch. For rear seat recline, snap
flap in six (6) places to back of front seat.
Never use stroller on stairs or escalators.
You may suddenly lose control of the
stroller or your child may fall out. Also,
use extra care when going up or down a
step or curb.
Avoid strangulation. DO NOT place
items with a string around your childs
neck, suspend strings from this prod-
uct, or attach strings to toys.
Models 7950, 7955,
7965 and 7970
Model No.
Serial No.
Dear Customer,
Please fill in the
model and serial
numbers above
from the label on
the rear leg of
your new stroller.
Page 2
Failure to follow these warnings and the assembly instructions
could result in serious injury or death.
Avoid possible tipping back. When
using with only one child, always
use front seat. When using with two
children, always place the child in
the front seat before placing the
other child in the rear seat. Always
remove the child from the rear seat
before removing the child from the
front seat.
Be certain the stroller is fully erected
and latched before allowing your
child near the stroller.
Use of the stroller with two children
weighing a total of more than 80 lbs.
(36.2 kg) will cause excessive wear
and stress on the stroller. The weight
in either seat should not exceed
40 lbs. (18.1 kg).
TO PREVENT A HAZARDOUS CONDITION,
do not place more than 10 lbs. (4.5 kg) in the
storage basket or more than 2 lbs. (0.9 kg) in
the canopy bag.
NEVER ALLOW YOUR STROLLER to be
used as a toy.
STROLLER TO BE USED only at walking
speed. Product not intended for use while
jogging, skating, etc.
DISCONTINUE USING YOUR STROLLER
should it become damaged or broken.
Never place child in the stroller with
head toward front of the stroller.
FOR ADDITIONAL IMPORTANT
INFORMATION, please see the
Helpful Hints and Care and
Maintenance sections in these
instructions.
Page 3
6785
751-6-99
To Unpack Stroller
Step 1.
Flatten stroller carton to
protect floor.
Open stroller on carton as
shown until latched.
Step 2.
Be sure frame is latched as
shown before continuing
assembly.
Step 1.
Snap swivel lock button onto
wheel mount as shown. This
must be done BEFORE pin is
inserted (next step).
Step 2.
Insert pin through hole in wheel
mount. Then push round end of
a front wheel assembly up onto
pin as shown until it snaps into
place.
Check wheel attachment by
pulling down on the front wheel
assembly.
Step 3.
Repeat above steps for the
other side.
Step 1.
Turn stroller over as shown.
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing, call Customer Service
at 1-800-345-4109 or visit our Internet website,
www.gracobaby.com.
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
No tools required for assembly.
Pin (2)
Rear axle
Frame
Front wheel
assembly (2)
Flattened
carton
Rear
canopy
Front canopy
(only on
some models)
Retainer
(2, 1 extra)
Rear wheel (2)
Cap
(2, 1 extra)
Rear hubcap (2,
only on some models)
To Assemble Front Wheels
Latch
To Assemble Rear Wheels
Swivel lock
button (2)
Insert pin
Push
wheels up
Round
end
Page 4
Spokes
toward
inside
Rear
axle
Retainer (red)
Wide end toward wheel
Hubcap (only on
certain models)
Step 2.
Place ONE rear wheel, red retainer, cap, and hubcap (only on
certain models) on one end of rear axle in order as shown
below. Push red retainer onto axle BEFORE attaching white
cap. Do not place other wheel on axle at this time.
Wheel
Cap (white)
Attach AFTER
retainer is
on axle
Snap red retainer into axle
groove. Then snap cap over the
red retainer as shown. Be sure
cap is snapped securely over
red retainer. Snap the hubcap
(only on some models) on last.
Step 3.
Unsnap the basket flap from the
rear brace, and slide rear axle
with wheel assembly through
the hole in one axle bracket.
Continue to push the rear axle
into the hole of the other axle
bracket.
Step 4.
Snap the basket flap around
both the rear axle and the rear
brace.
This may be easier if the
stroller is partially folded.
See the To Fold Stroller
instructions.
Step 5.
Place other rear wheel onto the
rear axle. Snap the red retainer
and cap onto the axle as shown
in Step 2.
Step 6.
Only on certain models, snap
the remaining hubcap onto
rear wheel to complete the
assembly.
To Unfold Stroller
Step 1.
Release the latch found on
one side of stroller.
Step 2.
Unfold stroller as shown.
Be certain the
stroller is fully erected and
latched before allowing your
child near the stroller.
To Raise Footrests
Lift footrest and hook wire into
footrest bracket.
To Use Brakes
Always apply
both brakes to park stroller.
Push DOWN to park.
Lift UP to stroll.
Page 5
Step 3.
To return seat back to a more upright position, push forward
on back until it snaps into desired position. (Front seat
middle position locks for safetyunlock by squeezing lever
before pushing into full upright position.)
10 11
9
751-6-99
Rear seat
Back of front seat
To Change to Swivel
or Non-swivel Wheels
Front swivel wheels lock for use on uneven surfaces such
as grass, stones or gravel.
Before locking swivels, first push stroller forward a few feet
to ensure that the wheels are correctly positioned.
Push buttons up or down, depending on model, to lock or
release swivels. Turn swivel to check that it is locked or
released.
Step 1.
Place crotch strap between
childs legs and snap both side
buckles to the center buckle.
Adjust belt as needed to get a
snug fit around your child.
Step 2.
Push in on front of buckle to
release.
To Secure Your Child
Avoid serious injury from falling or
sliding out. Always use seat belt.
To Adjust Backs
Step 1.
Push back of seat slightly
forward while squeezing
lever as shown to unlock.
Step 2.
Adjust to desired position.
Rear seat has four positions, front
seat has three. You may use any
combination of seat positions.
Child may slip
into leg openings and strangle.
NEVER use front seat in a
reclined carriage position unless
footrest is raised to cover the
front opening and wire is
snapped into lower notch.
NEVER use rear seat in a
reclined carriage position unless
footrest opening behind front
seat has first been closed by
snapping the flap in six places
to the back of the front seat.
Do not pull
on this bar!
To Install Rear Canopy
Step 1.
Fully recline the rear seat. Locate
small knobs on the inside of the
handle.
Step 2.
Hold canopy by mounting
brackets as shown. Push
brackets in slightly and align
holes in brackets with knobs
on handle. Mount brackets
onto knobs.
Step 3.
Slide brackets down to latch.
Be sure fabric is not caught
under brackets.
Step 4.
Snap canopy fabric to seat back.
Bracket
hole
Knob
Knob
Page 6
12
To Remove Rear Canopy
Step 1.
Fully recline the rear seat.
Step 2.
Unsnap canopy fabric from stroller.
Step 3.
Slide both brackets up, then push
brackets in slightly to remove canopy.
Slide up
and
push in
To Fold Stroller
NOTE: Before folding,
(1) adjust backs to upright position;
(2) fold canopy; (3) align front
wheels with frame.
Step 1.
Push on rod to fold as shown.
Step 2.
Release secondary latch as
shown.
Step 3.
Push handle forward.
Step 4.
Lock latch.
Step 1.
Fully recline the front seat.
Step 2.
Unsnap small flaps on top of
both armrests.
Step 3.
Make sure arrows on inside of
canopy bracket face toward the
front of stroller.
Step 4.
Insert brackets through elastic,
then through holes on armrests
as shown.
Step 5.
Push both brackets down at the
same time onto stroller frame until
they snap into place. Brackets
must fit over metal bars on inside
of frame. Be sure fabric is not
caught under brackets.
Step 6.
Resnap small flaps on armrests
when front canopy is not in use.
Push
Push
Metal bar
To Install Front Canopy
(found only on some models):
Align front
wheels
To Adjust Canopies
Push or pull canopy to desired
position.
Canopy bag (on certain models)
carries a maximum of 2 pounds
(0.9 kg).
Page 7
1413
751-6-99
Return the form below with payment to:
GRACO CHILDRENS PRODUCTS INC.
CUSTOMER SERVICE DEPARTMENT
P.O. BOX 100, MAIN STREET
ELVERSON, PA 19520
Model Number
(Must be filled in)
SHIP TO:
Name
Address
City, State, Zip
( )
Telephone
Check enclosed
(payable to Graco Childrens
Products Inc.)
Charge to credit card:
Visa
MasterCard
Discover
Account #:
Expiration date:
Signature:
Total:
Shipping
& handling: $5.00
6% sales tax
(PA only):
Total amount
due:
IF YOU NEED HELP
If you have any questions or if you need
any part not listed, please call toll-free:
1-800-345-4109
or visit our Internet website, www.gracobaby.com.
Seat assembly
Front seat soft pad
Rear seat soft pad
Front wheel assembly
Rear wheel
Rear axle
Slung basket
Front footrest cover
Rear footrest cover
Rear canopy fabric
Rear canopy frame
Rear canopy mounts
Front canopy
fabric & frame*
Hubcaps*
* Only on some models.
Replacement Parts
Instructions for ordering stroller parts:
Complete form at right. Your stroller model number
MUST be included on the form to ensure proper
replacement parts. Your model number can be
found on a sticker on the rear leg of your stroller.
Payment must accompany your order.
Parts List:
Seat assembly .........................
Front seat soft pad* .................
Rear seat soft pad* ..................
Front wheel assembly .............
(2 wheels per unit)
Rear wheel ..............................
Rear axle .................................
Slung basket ............................
Front footrest cover .................
Rear footrest cover ..................
Rear canopy fabric ..................
Rear canopy frame ..................
Rear canopy mounts (2) ..........
Front canopy fabric & frame* ..
Hubcaps* .................................
* Only on some models.
Price:**
$35.00
$18.00
$17.00
$16.00 (each)
$ 8.00
$ 7.00 (each)
$16.00
$13.00
$13.00
$12.00
$ 5.00
$ 5.00
$15.00
$ 7.00
** Prices subject to change without notice.
HELPFUL HINTS
IF WHEEL SQUEAKS, use a light
oil (e.g., WD-40, 3-in-1, or sewing
machine oil). It is important to get
the oil into the axle and wheel
assembly as shown.
WHEN USING YOUR STROLLER AT THE
BEACH, completely clean your stroller
afterward to remove sand and salt from
mechanisms and wheel assemblies.
CARE AND MAINTENANCE
DO NOT MACHINE WASH SEAT (with permanent
inner boards). It should only be wiped with a mild
detergent, taking care not to soak the material.
NO BLEACH.
REMOVABLE SEAT PAD may be machine washed
in lukewarm water on delicate cycle and drip-dried.
NO BLEACH.
FROM TIME TO TIME CHECK YOUR STROLLER for
loose screws, worn parts, torn material or stitching.
Replace or repair the parts as needed. Use only
Graco
®
replacement parts.
TO CLEAN STROLLER FRAME, use only household
soap or detergent and warm water. NO BLEACH.
EXCESSIVE EXPOSURE TO SUN OR HEAT could
cause fading or warping of parts.
Loading...