GENUINE GRACO PARTS AND ACCESSORIES
Drum-Mount
Suction Kit
SaniForce™ 515 Diaphragm Pumps
Important Safety Instructions
Read all warnings and instructions in the SaniForce 515 Air-Operated Diaphragm Pump
manual. Save all instructions.
Kit 262828
Ref. Description Qty.
1 ELBOW, reducer 1
2 TUBE, suction, drum length 1
3 BRACKET, mounting 1
4 ADAPTER, bung 1
5 WASHER, plain 4
6 SCREW, cap, hex head 4
7 NUT, hex, flange head 4
8 CLAMP, sanitary, 1.5 in. 1
9 GASKET, sanitary, 2 in., EPDM 1
10 GASKET, sanitary, 1.5 in., Buna-N 1
11 TRICLAMP, 2 in. 1
11
407018A
EN
6
8
10
1
9
5
7
4
3
2
ti18928a
See reverse for installation instructions.
Install the Suction Kit
1. Use the screws (6), washers (5), and nuts (7) to
mount the pump on the bracket (3).
2. Attach the elbow (1) and gasket (10) to the pump
inlet with the clamp (8). Tighten securely.
3. Place the mounted pump on the supply drum cover.
4. Remove the drum’s bung hole plug, and thread the
bung adapter (4) tightly into the bung hole.
5. Lower the tube (2) through the adapter (4) until it
rests on the bottom.
6. The supplied tube is long enough for the tallest
drums. If the tube is not the correct height to clamp
to the inlet elbow (1), the tube must be cut to fit.
a. Measure the distance between the bottom of
the flange on the elbow (1) and the top of the
flange on the tube (2).
c. When the tube is the correct length, slide it back
through the bung adapter (4) into the drum.
7. Attach the elbow (1) and gasket (9) to the bung
adapter (4) with the clamp (11).
ti18927a
b. Remove the tube. Add 1/2 in. to your measure-
ment. Mark and cut this amount off the bottom
of the tube (the end with no flange).
All written and visual data contained in this document reflects the latest product information available at the time of publication.
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2012, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
Graco reserves the right to make changes at any time without notice.
Original instructions. This manual contains English. MM 407018
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
www.graco.com
Revision A, March 2012
ti18927a